List of top Questions asked in Tamil Nadu Common Entrance Test

Match list I with list II and select the correct answer using the code given: 
Shaft Arrangement
Match list I with list II and select the correct answer using the code given:
Gear Type
Match list I with list II and select the correct answer using the code given:
Investment casting
Match list I with list II and select the correct answer using the code given:
Quick return mechanism
Match list I with list II and select the correct answer using the code given:
Interpolations
What is the angle between the steering axis and the vertical when viewed from the side of the vehicle?
Micro explosion occurs at the temperature of about:
Transfer case is used in a:
Nose radius is expressed in:
As per AIS 052, School Bus are come under the TYPE
Outer part of the tyre that extends from the bead to the tread is
Which of the following sensors is usually installed in the exhaust manifold?
Which of the following methods requires medium for heat transfer?
Piston crevice volume is one of the reasons for ___________ emission:
What is the maximum power transmitted by a single plate clutch at speed of 3600 rev/min if the coefficient of friction is 0.4 and the linings have a radius of 160mm inner and 190mm outer? The total spring force is 2.5 kN.
Which of the following materials is used in engine noise control?
For the same maximum pressure and temperature, what is the order of efficiency of Otto, Diesel, and Dual cycle?
When there is a reduction in amplitude over every cycle of vibration, then the body is said to have
Solar radiation is increased inside the passenger compartment by increasing __________ of a car.
Biogas is:
Blue smoke is caused by:
Hydrogen combustion with air at stoichiometric condition results in:
Hydrogen Induction in diesel engine will:
"The emissive power of a black body varies linearly to the fourth power of its absolute temperature" This statement is called:
The following diverts the power at right angles towards the driving wheels: