Question:
Which one of the following is an open pair?
Which one of the following is an open pair?
Show Hint
Open pairs typically allow more complex motion but may require more precise manufacturing to ensure proper function.
Updated On: Feb 7, 2025
- Ball and socket joint
- Journal bearing
- Lead screw and nut
- Cam and follower
Hide Solution
Verified By Collegedunia
The Correct Option is C
Solution and Explanation
Defining an open pair.
An open pair consists of two elements where the mating is not complete or encased. The lead screw and nut pair allow relative motion in a helical form and are partially exposed, making it an open pair.
An open pair consists of two elements where the mating is not complete or encased. The lead screw and nut pair allow relative motion in a helical form and are partially exposed, making it an open pair.
Was this answer helpful?
0
0
Top Questions on Mechanics
- A bullet is fired upwards at an angle of \(30^\circ\) to the horizontal from a point P on a hill, and it strikes a target which is 80 m lower than P. The initial velocity of the bullet is 100 m/s. Calculate the maximum height to which the bullet will rise above the horizontal. Assume \( g = 9.81 \) m/s\(^2\).
- Currently, eighty-five percent of all neck injuries are caused by rear-end car collisions. To alleviate this problem, an automobile seat restraint has been developed that provides additional pressure contact with the cranium. During dynamic tests, the distribution of load on the cranium has been plotted and shown to be parabolic. Determine the equivalent resultant force and its location, measured from point A.
- Mass moment of inertia of a thin rod about its one end is ________ the mass moment of inertia of the same rod about its mid-point.
- In the case of a flywheel, the maximum fluctuation of energy is the:
- The resultant of two forces \( P \) and \( Q \) (such that \( P>Q \)) acting along the same straight line, but in opposite direction, is given by:
View More Questions
Questions Asked in TANCET exam
- The centrifugal force (N) acting on a material mass 2g present at the tip of a beater of radius 25 cm rotating at 600 rpm is
- TANCET - 2024
- Yarn Engineering
- Select the correct match
- TANCET - 2024
- Yarn Engineering
- Two yarns of count X each are doubled and plied. The ratio of resultant count of two ply yarn expressed in tex system and Ne system is_______. Neglect contraction due to twist.
- TANCET - 2024
- Yarn Engineering
- A reed has 15 dents/cm, and the warp is drawn in two ends per dent. If the finished fabric is 1.4 m wide compared with 1.47 m wide in the reed, what is the finished fabric sett?
- TANCET - 2024
- Fabric Engineering
- Among the following systems of drafting, the objective of which is to reduce the friction between adjacent warp ends?
- TANCET - 2024
- Fabric Engineering
View More Questions