Question:
In which of the following welding methods is the Heat affected zone (HAZ) minimum?
In which of the following welding methods is the Heat affected zone (HAZ) minimum?
Show Hint
LASER welding is ideal for applications requiring high precision and minimal thermal distortion.
Updated On: Feb 7, 2025
- LASER welding
- Gas welding
- Arc welding
- Thermite welding
Hide Solution
Verified By Collegedunia
The Correct Option is A
Solution and Explanation
Analyzing the characteristics of welding methods.
LASER welding minimizes the heat affected zone due to its highly focused beam, which delivers precise energy to a small area, reducing the spread of heat into surrounding metal.
LASER welding minimizes the heat affected zone due to its highly focused beam, which delivers precise energy to a small area, reducing the spread of heat into surrounding metal.
Was this answer helpful?
0
0
Top Questions on Production Technology
- Identify the correct type of defect for casting shown below:
- TANCET - 2024
- Mechanical Engineering
- Production Technology
- In a machining operation that approximates orthogonal cutting, the cutting tool has a rake angle of 10°. The chip thickness before the cut \(t_0 = 0.50\) mm and the chip thickness after the cut \(t_c = 1.125\) mm. The shear plane angle \(\phi\) is ——–––––––––.
Assuming \(\sin 10^\circ = 0.173\) and \(\cos 10^\circ = 0.984\).- TANCET - 2024
- Mechanical Engineering
- Production Technology
- Identify the operation related to drilling which is illustrated in Figure below.
- TANCET - 2024
- Mechanical Engineering
- Production Technology
- Which of the following is an incorrect operation in relation to the finishing processes employed for gear teeth?
- TANCET - 2024
- Mechanical Engineering
- Production Technology
- In laser beam welding, ——––––––––– are associated with the evolution of vapor from the surface of the material to produce a needle-like, vapor-filled cavity or keyhole in the work piece through which the beam can penetrate.
- TANCET - 2024
- Mechanical Engineering
- Production Technology
View More Questions
Questions Asked in TANCET exam
- The centrifugal force (N) acting on a material mass 2g present at the tip of a beater of radius 25 cm rotating at 600 rpm is
- TANCET - 2024
- Yarn Engineering
- Select the correct match
- TANCET - 2024
- Yarn Engineering
- Two yarns of count X each are doubled and plied. The ratio of resultant count of two ply yarn expressed in tex system and Ne system is_______. Neglect contraction due to twist.
- TANCET - 2024
- Yarn Engineering
- A reed has 15 dents/cm, and the warp is drawn in two ends per dent. If the finished fabric is 1.4 m wide compared with 1.47 m wide in the reed, what is the finished fabric sett?
- TANCET - 2024
- Fabric Engineering
- Among the following systems of drafting, the objective of which is to reduce the friction between adjacent warp ends?
- TANCET - 2024
- Fabric Engineering
View More Questions