List of top Automobile Engineering Questions

Match list I with list II and select the correct answer using the code given:
Investment casting
Match list I with list II and select the correct answer using the code given:
Quick return mechanism
Mass moment of inertia of a thin rod about its one end is ________ the mass moment of inertia of the same rod about its mid-point.
Match list I with list II and select the correct answer using the code given: 
Shaft Arrangement
Wheel alignment servicing equipment is used to measure:
A higher value of flexural rigidity indicates:
In which of the following welding methods is the Heat affected zone (HAZ) minimum?
Which of the following methods requires medium for heat transfer?
What is the angle between the steering axis and the vertical when viewed from the side of the vehicle?
Which one of the following is an open pair?
A porter governor is a______ governor.
In the case of a flywheel, the maximum fluctuation of energy is the:
If the diameter of a shaft is subjected to torque alone is doubled, then the horse power can be increased to:
Match list I with list II and select the correct answer using the code given:
Gear Type
Consider the following statements:
i. Heat can flow of itself from lower temperature body to a higher temperature body
ii. A heat pump maintains a body at a temperature higher than the temperature of the surroundings
iii. The COP of a heat pump is greater than the COP of a refrigerator by unity
iv. The COP of a refrigerator using heat addition(Q1) and heat rejection(Q2) is expressed as \( \frac{Q_1}{Q_1 - Q_2} \)
Nose radius is expressed in:
The resultant of two forces \( P \) and \( Q \) (such that \( P>Q \)) acting along the same straight line, but in opposite direction, is given by:
Consider the following statements about non-conventional machining processes: 
i. Hard materials can be easily machined without being damaged 
ii. Complex shapes are easily produced 
iii. They have low specific energy consumption 
iv. Tools need not be harder than work piece
The ideal vapor power cycle is:
Match list I with list II and select the correct answer using the code given:
Interpolations
The ratio of static friction to dynamic friction is always:
"The emissive power of a black body varies linearly to the fourth power of its absolute temperature" This statement is called:
Consider the following statements: i. Volume, temperature, and pressure are macroscopic quantities
ii. Intensive properties are independent of mass
iii. Extensive properties are related to mass
iv. Volume and temperature are intensive properties Of these statements,
For the same maximum pressure and temperature, what is the order of efficiency of Otto, Diesel, and Dual cycle?
Consider the following statements about theory of simple bending:
(i) Beam material is isotropic and homogeneous
(ii) Elastic modulus of beam material is more in tension than in compression
(iii) Radius of curvature is large Of these statements,