>
Telangana State Post Graduate Engineering Common Entrance Test
>
Electronics and Communication Engineering
List of top Electronics and Communication Engineering Questions asked in Telangana State Post Graduate Engineering Common Entrance Test
A narrowband FM does not have the following feature
TS PGECET - 2024
TS PGECET
Electronics and Communication Engineering
communication systems
The figure of merit ratio of FM to PM for single tone modulating signal is
TS PGECET - 2024
TS PGECET
Electronics and Communication Engineering
communication systems
The image channel rejection in superheterodyne receiver comes from
TS PGECET - 2024
TS PGECET
Electronics and Communication Engineering
communication systems
The plot of modulation index versus carrier amplitude yields a
TS PGECET - 2024
TS PGECET
Electronics and Communication Engineering
communication systems
The positive RF peaks of an AM voltage rise to maximum value of 12V and drop to a minimum value of 4V. Assuming single tone modulation, the modulation index is
TS PGECET - 2024
TS PGECET
Electronics and Communication Engineering
communication systems
Thermal noise is independent of
TS PGECET - 2024
TS PGECET
Electronics and Communication Engineering
communication systems
The characteristic equation of a control system is given by \( s(s+1)(s^2+2s+1)+k(s+2)=0 \). The angles of asymptotes of the root loci are
TS PGECET - 2024
TS PGECET
Electronics and Communication Engineering
Control Systems
The limit cycles describe the ____ of non-linear systems
TS PGECET - 2024
TS PGECET
Electronics and Communication Engineering
Control Systems
Consider an open-loop unstable system with the transfer function \( G(s)H(s) = \frac{s+2}{(s+1)(s-1)} \) when the feedback path is closed, then the system is
TS PGECET - 2024
TS PGECET
Electronics and Communication Engineering
Control Systems
The main advantage of Bode plot is to
TS PGECET - 2024
TS PGECET
Electronics and Communication Engineering
Control Systems
Addition of a pole at the origin to a transfer function rotates the polar plot at zero and infinite frequencies by a further angle of
TS PGECET - 2024
TS PGECET
Electronics and Communication Engineering
Control Systems
Generally, the bandwidth of a control system indicates ____ characteristic of the system.
TS PGECET - 2024
TS PGECET
Electronics and Communication Engineering
Control Systems
Position, velocity and acceleration errors of type 2 control system respectively, are
TS PGECET - 2024
TS PGECET
Electronics and Communication Engineering
Control Systems
From the following Routh array table, which tells us that there are
\( S^n \)
Col 1
Col 2
Col 3
\( S^5 \)
2
1
\( S^4 \)
3
2
1
\( S^3 \)
\(-\frac{4}{3}\)
\(-\frac{2}{3}\)
\( S^2 \)
\(\frac{1}{2}\)
1
\( S^1 \)
2
\( S^0 \)
1
TS PGECET - 2024
TS PGECET
Electronics and Communication Engineering
Control Systems
The \(a_{ij}\) is the ___ of the branch directed from node \(x_i\) to \(x_j\) in signal flow graph.
(Note: The blank is after "is the". Assuming it asks what \(a_{ij}\) represents.)
TS PGECET - 2024
TS PGECET
Electronics and Communication Engineering
Control Systems
LEA CX,[BX][SI] instruction of 8086 microprocessor indicates where (BX) and (SI) represent the content of BX and SI respectively
TS PGECET - 2024
TS PGECET
Electronics and Communication Engineering
Microprocessors
For n inputs, k product terms and m outputs, the internal logic of the PLA consists of
TS PGECET - 2024
TS PGECET
Electronics and Communication Engineering
Digital Electronics and Logic Gates
The characteristic equation of SR flip-flop is
TS PGECET - 2024
TS PGECET
Electronics and Communication Engineering
Digital Electronics and Logic Gates
In priority encoder, if two or more inputs are equal to ____ will take highest priority
TS PGECET - 2024
TS PGECET
Electronics and Communication Engineering
Digital Electronics and Logic Gates
The 8-to-3 encoder is also called
TS PGECET - 2024
TS PGECET
Electronics and Communication Engineering
Digital Electronics and Logic Gates
The values of the segments 'abcdefg' of seven segment display for the BCD input of '0101'?
(Assuming standard segment labeling: a-top, b-top-right, c-bottom-right, d-bottom, e-bottom-left, f-top-left, g-middle. And BCD '0101' is decimal 5.)
TS PGECET - 2024
TS PGECET
Electronics and Communication Engineering
Digital Electronics and Logic Gates
Quantization error in ADC is due to
TS PGECET - 2024
TS PGECET
Electronics and Communication Engineering
Digital Electronics and Logic Gates
An n-to-m line decoder is used to generate
(Note: "n-to-m line decoder" where \(m = 2^n\))
TS PGECET - 2024
TS PGECET
Electronics and Communication Engineering
Digital Electronics and Logic Gates
Any Boolean function of n+1 variables can be implemented with ___ multiplexer
TS PGECET - 2024
TS PGECET
Electronics and Communication Engineering
Digital Electronics and Logic Gates
Simplify \( AB + A\bar{C} + \overline{A}BC(AB+C) \)
TS PGECET - 2024
TS PGECET
Electronics and Communication Engineering
Digital Electronics and Logic Gates
Prev
1
2
3
4
5
Next