List of top Water Engineering and Management Questions asked in Common University Entrance Test

In a static fluid with $y$ as the vertical direction, the pressure variation is given by:
1 Stoke is equal to:
Basalt is a:
The shine of a mineral is known as:
The reduced level of a factory floor is 36.00 m, and the staff reading on the f loor is 1.40 m. The staff reading when held inverted with the bottom touching the Tee-beam of the roof is 3.67 m. What will be the height of the beam above the floor?
The rock fragments contributed by the frost action, mainly along valley-sides and the adjoining cliffs, and carried away by glaciers are known as
In case of angular measurements being more precise than linear measurements, the traverse can be balanced by:
For which of the following permanent adjustments of a theodolite is the spire test used
Find the magnetic declination if the magnetic bearing of the sun at noon is $356^\circ$.
Oblique offsets are used to
Which Act makes the provision for the statutory fixation of a minimum rate of wages in the industry?
The distance AB on the ground as measured on a plan drawn to a scale of 1 cm = 50 m was found to be 500 m. Later, it was detected that the surveyor wrongly used a scale of 1 cm = 40 m in the calculations. What will be the true length of the line AB?
Surveys which are carried out to indicate the inequalities of land surface and to depict the mountain, water bodies, woods, etc., are known as:
What will be the sag correction for a 100 m tape which is suspended between the ends under a pull of 10 N? The total weight of the tape is 12 N.
Geodimeter is based on:
What will be the expected time for driving the precast piles for a bridge abutment activity having optimistic time 22, most likely time 30, and pessimistic time 50?
Out of the following, which drawing together with other documents like the bill of quantities, describes the project scheme to the contractor so that he can price the construction work accordingly?
Which type of contract is not suitable for difficult foundations, excavation of uncertain character, and projects susceptible to unpredictable hazards and variations?
In case of a circular section of diameter d, the section modulus is given by:
Two shafts of solid circular cross-section identical except their diameters are subjected to the same torque (T). What will be the ratio of strain energies (U1/U2) stored in both shafts if the diameter of the first shaft is d1 and diameter of the second shaft is d2, respectively?
The circumferential strain in case of a thin cylindrical shell, when subjected to internal pressure ($p$), is equal to:
Which construction stage is required to carry out technical investigations such as soil investigation, topographic investigation, material supply, and market survey, etc.?
Which of the following formations does not contain any groundwater?
Coulomb’s Theory is also known as:
How much force is required to punch a 20 mm diameter hole in a plate that is 25 mm thick?