List of top Questions asked in CUET (PG)

Capitalized cost comparison method is used for comparing alternatives having:

A company spends a considerable amount on publicity to promote sales. This expenditure in a break-even chart is shown below the:

Routh test cannot be used to test the stability of a control system containing:

The first-order thermometer used has a time constant of 50 s. If it is subjected to a sinusoidal input cycling at 0.002 Hz, then the time lag produced in the instrument will be:

Sugar is leached from sugar beets with:

Higher holdup of solids in the rotary dryer results in:

The grading of nitrogenous fertilizers is based on:

Bleaching of paper pulp is done by:

XLPE is the trade name of

Strength of sulphuric acid can be measured by:

An additional step in the manufacture of paper from bagasse as compared to that from bamboo is:

Heat transfer takes place according to:

HETP is numerically equal to HTU only when the operating line:

Flash distillation is used at a large scale in:

In the absorption of a solute gas from a mixture containing inerts in a solvent, it has been observed that the overall gas transfer coefficient is nearly equal to the individual gas film transfer coefficient. It may therefore be concluded that:

In a small column, local efficiency is equal to Murphree efficiency, and in a large column, local efficiency is:

Which of the following is a continuous filter?

In a mixing tank operating at a very high Reynolds number 104, if the diameter of the im peller is doubled, keeping other conditions constant, the power required increases by a factor of:

The maximum heat loss from a pipe occurs when the critical radius equals:

For laminar film condensation, what is the ratio of heat transfer to a horizontal tube of large diameter to that of a vertical tube of the same size for the same temperature difference?

For the same process temperatures, the ratio of the LMTD in parallel flow to the LMTD in counter-current flow in a liquid-liquid heat exchanger is always:

When a longitudinal baffle is placed across the shell, the shell-side fluid is forced to pass through the heat exchanger:

Industrial paddle agitators turn at speed between:

Which of the following size reduction equipment can accept feed sizes of 10 inches and up?

Arrange the following flow measuring devices in the increasing order of head loss caused by them:
(A). Flow nozzle
(B). Venturimeter
(C). Orifice meter