The ore that is concentrated by Froth Floatation process is
Show Hint
Ores concentrated by the froth floatation process include zinc blende (ZnS), Galena (PbS), and cinnabar (HgS).
- Bauxite
- Malachite
- Zincite
- Cinnabar
The Correct Option is D
Approach Solution - 1
The process of Froth floatation is used to concentrate only sulphide ores.
Cinnabar, HgS is a sulphide ore. Therefore, the froth floatation method is used for its concentration.
Approach Solution -2
Ores concentrated by the froth floatation process include zinc blende (ZnS), Galena (PbS), and cinnabar (HgS).
Hence, option D is correct.
Approach Solution -3
Here,
Ores that are concentrated by the fourth floatation process include Galena (PbS), zinc blende (ZnS), and cinnabar (HgS). The process of Froth floatation is used to concentrate only sulfide ores.
Hence, The correct option will be D.
Top Questions on Concentration of ores
- Which of the following are carbonate ores?
I. Siderite
II. Kaolinite
III. Calamine
IV. Sphalerite- AP EAPCET - 2025
- Chemistry
- Concentration of ores
- Identify the sulphide ore among the following:
- TS POLYCET - 2025
- Chemistry
- Concentration of ores
- Which of the following methods is used for the concentration of ore?
- TS POLYCET - 2025
- Chemistry
- Concentration of ores
- Pyrolusite ore is:
- BCECE Nursing - 2024
- Chemistry
- Concentration of ores
- A → P is a zero-order reaction. At 298 K, the rate constant of the reaction is \( 1 \times 10^{-3} \) mol L\(^{-1}\) s\(^{-1}\). Initial concentration of 'A' is 0.1 mol L\(^{-1}\). What is the concentration of 'A' after 10 sec?
- AP EAMCET - 2024
- Chemistry
- Concentration of ores
Questions Asked in KCET exam
A wooden block of mass M lies on a rough floor. Another wooden block of the same mass is hanging from the point O through strings as shown in the figure. To achieve equilibrium, the coefficient of static friction between the block on the floor and the floor itself is
- KCET - 2025
- Newtons Laws of Motion
- If \( A \) is a square matrix of order \( 3 \times 3 \), \( \det A = 3 \), then the value of \( \det(3A^{-1}) \) is:
- KCET - 2025
- Matrices
- The number of orbitals associated with 'N' shell of an atom is
- KCET - 2025
- Atomic Physics
- The system of equations \( 4x + 6y = 5 \) and \( 8x + 12y = 10 \) has:
- KCET - 2025
- Linear Equations
- If A and B are two matrices such that AB is an identity matrix and the order of matrix B is \(3 \times 4\), then the order of matrix A is:
- KCET - 2025
- Matrices
Concepts Used:
Concentration of Ore
The concentration of ore, also known as ore enrichment, is the process of removing gangue particles from ore in order to enhance the percentage of metal in the ore. The difference in physical or chemical properties of the ore and the impurities determines the procedures used to remove impurities from the ores.
Methods of Concentration of Ore:
- Hand-picking - It was the traditional system of directly concentrating ore with the hands. With the use of a hammer, the gangue or adhering solid matrix is removed from the ore in this procedure. The separation and identification of gangue are based on colour or lump form differences.
- Hydraulic Washing - On passing the ore via an upward stream of water, the lighter gangue particles are separated from the heavier metal ore. This is a gravity separation method.This process is used to enrich ores that are heavier than the gangue particles that are present in them. A stream of water is run through crushed and finely powdered ore in this procedure. Water washes away the lighter gangue particles, leaving the larger ore particles behind.
- Froth Floatation Process - The purpose of this process is to extract gangue from sulfide ores. The ore is pulverized and mixed with water to form a suspension. Collectors and Froth Stabilizers are added to this. Collectors like pine oils, fatty acids, etc. boost the metal part of the ore’s non-wettability, allowing it to form a froth.