The depletion layer in the p-n junction region is caused by
- drift of holes
- diffusion of charge carriers
- migration of impurity ions
- drift of electrons.
The Correct Option is B
Solution and Explanation
Top Questions on P-N Junction
- If a p-n junction diode is forward biased, then:
- KEAM - 2025
- Physics
- P-N Junction
- When a potential difference V is applied across a wire of resistance R, it dissipates energy at a rate W. If the wire is cut into two halves and these halves are connected mutually parallel across the same supply, the same supply, the energy dissipation rate will become:
- JEE Main - 2024
- Physics
- P-N Junction
- Consider the following statements A and B and identify the correct answer:
A. For a solar-cell, the I-V characteristics lies in the IV quadrant of the given graph.
B. In a reverse biased pn junction diode, the current measured in (µA), is due to majority charge carriers.- NEET (UG) - 2024
- Physics
- P-N Junction
The following are the graphs of potential barrier versus width of the depletion region for a p-n junction diode.
Which of the following is correct?
- COMEDK UGET - 2024
- Physics
- P-N Junction
- A p-n junction diode is connected to a battery of emf 5.7 V in series with a resistor 5k \( \Omega \) such that it is forward biased. If the barrier potential of the diode is 0.7 V, neglecting the diode resistance, the current in the circuit is
- KCET - 2024
- Physics
- P-N Junction
Questions Asked in NEET exam
The current passing through the battery in the given circuit, is:
- NEET (UG) - 2025
- Current electricity
A bob of heavy mass \(m\) is suspended by a light string of length \(l\). The bob is given a horizontal velocity \(v_0\) as shown in figure. If the string gets slack at some point P making an angle \( \theta \) from the horizontal, the ratio of the speed \(v\) of the bob at point P to its initial speed \(v_0\) is :
- NEET (UG) - 2025
- Pendulums
- Two cities X and Y are connected by a regular bus service with a bus leaving in either direction every T min. A girl is driving scooty with a speed of 60 km/h in the direction X to Y. She notices that a bus goes past her every 30 minutes in the direction of her motion, and every 10 minutes in the opposite direction. Choose the correct option for the period T of the bus service and the speed (assumed constant) of the buses.
- NEET (UG) - 2025
- Relative Velocity
- The intensity of transmitted light when a polaroid sheet, placed between two crossed polaroids at \(22.5^\circ\) from the polarization axis of one of the polaroids (\(I_0\) is the intensity of polarised light after passing through the first polaroid):
- NEET (UG) - 2025
- Polarization
A full wave rectifier circuit with diodes (\(D_1\)) and (\(D_2\)) is shown in the figure. If input supply voltage \(V_{in} = 220 \sin(100 \pi t)\) volt, then at \(t = 15\) msec:
- NEET (UG) - 2025
- Semiconductor Diode
Concepts Used:
P-n Junction
A P-N junction is an interface or a boundary between two semiconductor material types, namely the p-type and the n-type, inside a semiconductor.
Biasing conditions for the p-n Junction Diode:
in p-n junction diode two operating regions are there:
- P-type
- N-type
There are three biasing conditions for p-n junction diode are as follows:
- Zero bias: When there is no external voltage applied to the p-n junction diode.
- Forward bias: P-type is connected to positive terminal of the voltage potential while n-type is connected to the negative terminal.
- Reverse bias: P-type is connected to negative terminal of the voltage potential while n-type is connected to the positive terminal.