List of top Questions asked in CUET (PG)

The rainfall on five successive days on a catchment was 2 cm, 6 cm, 9 cm, 5 cm, and 3 cm. If the φ-index for the storm is taken as 3 cm/day, the total direct runoff from the catchment will be:
A point load applied at shear center induces
A beam has the same section throughout its length with moment of inertia \(I = 1 \times 10^8 \, \text{mm}^4\). It is subjected to a uniform BM = 40 kN·m, \(E = 2 \times 10^5 \, \text{N/mm}^2\). What is the radius of curvature of the circle into which the beam will bend in the form of an arc of a circle?
The Penman’s evapotranspiration equation is based on
What will be the degree of BMD curve, if the load intensity is of \(n\) degree?
A beam of triangular cross-section is subjected to a shear force of 50kN. The base width of the section is 250 mm and the height is 200 mm. The beam is placed with its base horizontal. The shear stress at the neutral axis will be nearly-
Earliest finish of an activity is always:
Consider the following salient points in a stress-strain curve of mild steel bar: (A) Yield point
(B) Breaking point
(C) Proportionality limit
(D) Ultimate point
The correct sequence in which they occur while testing the mild steel bar in tension from initial zero strain to failure is:
What are the support reactions at the fixed end of the cantilever beam of 3 m length as shown in the diagram below?
The failure theory which is the most conservative for ductile materials is
The reduction in project time normally results in
Consider the following characteristics of contour: (A) A uniform slope is indicated when contour lines are spaced uniformly
(B) Contour lines cannot go anywhere but can close on themselves
(C) A set of closed contours indicates a depression or a summit, according to the lower or higher values being respectively inward
(D) A contour is an imaginary line passing through the points of an equal level on the surface of earth
Choose the correct answer from the options given below:
Consider the following statements:
(A) Engineering survey is used to collect requisite data for planning, design and execution of engineering projects.
(B) Reconnaissance survey is used to determine the feasibility and estimation of a scheme.
(C) Route survey is used for depiction of topography of a region.
(D) Archaeological survey is used for determining unearthing relics of antiquity.
Choose the correct answer from the options given below:
As per Indian standard specifications, the length of one link in 30 meter chain is:
What is the volume of a 6 m deep tank having rectangular shaped top 6 m $\times$ 4 m and bottom 4 m $\times$ 2 m? (use mean-area method)
In proportion of concrete mix, 1:12 (M 25) represents
As per IS code, the standard size of the brick in mm is:
The length of the survey line was measured with a 30 m tape and was found to be 1000 m. As a check, the length was again measured with another 20 m tape, and was found to be 1010 m. On comparing the 30 m tape with a test gauge, it was found to be 0.10 m too long. Find the actual length of the 20 m chain.
The magnetic bearing of line AB is 88°45'. Calculate the true bearing if the magnetic declination is 5°30' east.
The R.L. of the floor of a factory is 30.500. Staff reading on the floor is 1.610 m and staff reading when the staff is held inverted with the bottom touching the tie beam of the roof truss is 3.700 m. Find the height of the tie beam above the floor.
The fore bearing of line AB is 15°30'. What will be the back bearing of the line AB?
The minimum size of glass tubing that can be used to measure water level, if the capillary rise in the tube is not to exceed 0.25 cm. (Take surface tension of water in contact air as 0.0075 kg(f)/m).
For the flow through a pipe, if Reynolds's number is greater than 4000, it indicates:
Dynamic viscosity of a fluid is 2.2 poise and specific gravity is 0.7. Then kinematic viscosity in SI units is:
In order to determine the workability of a concrete mixture, the recommended tests are: (A) Flow test
(B) Compaction Factor test
(C) Flexural strength test
(D) Slump test
Choose the correct answer from the options given below: