List of top Questions asked in CUET (PG)

Match List I with List II

	LIST I		LIST II
A.	Sudden closure sluice gate	I.	Uniform flow
B.	Hydraulic jump in a stiling basin	II.	Rapidly varied flow
C.	Spreading irrigation water	III.	Usteady flow
D.	Flow in the main irrigation canal	IV.	Spatially varied

Choose the most appropriate answer from the options given below:

According to Darcy's law, for ground water movement velocity is proportional to.

Match List I with List II

	LIST I (Type of Precipitation)		LIST II (Principle causes)
A.	Lacustrine soil	I.	Transportation by wind
B.	Alluvial soil	II.	Transportation by running water
C.	Aeoline soil	III.	Deposited at the bottom of lakes
D.	Marine soil	IV.	Deposited in sea water

Choose the most appropriate answer from the options given below:

Reduction in volume of soil primarily due to squeezing out of water from winds is called.

The change that take place during the process of consolidation of a saturated clay would include.

Match List I with List II

	LIST I  (Measuring device)		LIST II (Soil Parameter)
A.	Pycnometer	I.	Compressibility
B.	Hydrometer	II.	Permeability
C.	Oedometer	III.	Specific gravity
D.	Parameter	IV.	Particle size analysis

Choose the most appropriate answer from the options given below:

Match List I with List II

	LIST I  I (Soil)		LIST II (Group Symbol)
A.	Clayly gravel	I.	SM
B.	Clayly sand	II.	OH
C.	Organic clay	III.	SC
D.	Silty sand	IV.	GC

Choose the most appropriate answer from the options given below:

What is hydrological cycle?

Hydrograph is the graphical representation of.

Given below are two statements: one is labelled as Assertion A and the other is labelled as Reason R.
Assertion A: Humidity decrease with altitude 
Reason R: At higher altitude the convective currents are very much reduced 
In the light of the above statements, choose the most appropriate answer from the options given below

Penman's equation is based on

Match List I with List II

	LIST I (Type of Precipitation)		LIST II (Principle causes)
A.	Convective	I.	Pressure difference
B.	Cylonic	II.	Mountain barrier
C.	Frontal	III.	Temperature difference
D.	Orographic	IV.	Warm and cold air masses

Choose the most appropriate answer from the options given below:

Match List I with List II

	LIST I (Type of Precipitation)		LIST II (Principle causes)
A.	Anemometer	I.	Humidity
B.	Rain simulator	II.	Evapotranspiration
C.	Lysimeter	III.	Infiltration
D.	Hygro meter	IV.	Wind speed

Choose the most appropriate answer from the options given below:

A 6-hour storm with hourly intersities of 7, 18, 25, 12, 10 and 3mm per hour produced a run off 33 mm. Then the Φ index is

What is the ratio of maximum shear stress to average shear stress for a circular section

Match List I with List II

	LIST I		LIST II
A.	\(\frac{σ ^2v}{2E}\)	I.	Axial load
B.	\(\frac{I^2v}{2G}\)	II.	Bending load
C.	\(\frac{I^2v}{4G}\)	III.	Shear load
D.	\(∫^l_0\frac{m^2xdx}{2EI}\)	IV.	Torsional load

Choose the most appropriate answer from the options given below:

For a given activity, the optimistic time, pessimistic time and most probable estimates are 5, 17, 8 days respectively. The expected time is

Match List I with List II

	LIST I		LIST II
A.	Used for recording instructions given by the executive engineer at site	I.	Co-ordination
B.	Used widely for civil engneering construction	II.	Unity command
C.	One of the Principle organisation	III.	Line organisation
D.	One of the function of management	IV.	Site order book

Choose the most appropriate answer from the options given below:

Match List I with List II

	LIST I		LIST II
A.	Activity	I.	Resourceless element
B.	Event	II.	Resource consuming element
C.	Dummy	III.	Spare time
D.	Float	IV.	Instantaneous stage

Choose the most appropriate answer from the options given below:

A serious limitation of inter dependencies between various activities is generally observed in.

The radius of mohr's circle of stress of a strained element is 20 N/mm2 and minor principle tensile stress is 10 N/mm2 the major principle stress is

Survey of India was Publicity toposheet using a scale of

The method of orienting a plane table with two inaccessible points is known as.

Match List I with List II

	LIST I		LIST II
A.	Shear centre	I.	Tension
B.	Principal plane	II.	slope
C.	Fixed end	III.	Shear stress
D.	Middle third Rule	IV.	Twisting

Choose the most appropriate answer from the options given below:

If a circular shaft is subjected to a torque T and a bending moment M, the ratio of maximum shear stress to maximum bending stress given by: