Identify the metal which is not common to German Silver and Brass.
- Cu
- Zn
- Fe
- Ni
The Correct Option is A
Solution and Explanation
Top Questions on Concentration of ores
- A → P is a zero-order reaction. At 298 K, the rate constant of the reaction is \( 1 \times 10^{-3} \) mol L\(^{-1}\) s\(^{-1}\). Initial concentration of 'A' is 0.1 mol L\(^{-1}\). What is the concentration of 'A' after 10 sec?
- AP EAMCET - 2024
- Chemistry
- Concentration of ores
- Which of the following metals can be extracted through alkali leaching technique?
- JEE Main - 2023
- Chemistry
- Concentration of ores
The methods NOT involved in concentration of ore are
A Liquation
B Leaching
C Electrolysis
D Hydraulic washing
E Froth floatation
Choose the correct answer from the options given below :- JEE Main - 2023
- Chemistry
- Concentration of ores
- Given below are two statements:
Statement I : In froth floatation method a rotating paddle agitates the mixture to drive air out of it.
Statement II : Iron pyrites are generally avoided for extraction of iron due to environmental reasons.
In the light of the above statements, choose the correct answer from the options given below:- JEE Main - 2023
- Chemistry
- Concentration of ores
- Ferric oxide in blast furnace's upper half is mainly reduced by:
- CUET (UG) - 2023
- Chemistry
- Concentration of ores
Questions Asked in AP EAMCET exam
Arrange the following in increasing order of their pK\(_b\) values.
- AP EAMCET - 2024
- Molecular Polarity
What is Z in the following set of reactions?
- AP EAMCET - 2024
- Molecular Polarity
Acetophenone can be prepared from which of the following reactants?
- AP EAMCET - 2024
- Molecular Polarity
What are \(X\) and \(Y\) in the following reactions?
- AP EAMCET - 2024
- Molecular Polarity
What are \(X\) and \(Y\) respectively in the following reaction?
- AP EAMCET - 2024
- Molecular Polarity
Concepts Used:
Concentration of Ore
The concentration of ore, also known as ore enrichment, is the process of removing gangue particles from ore in order to enhance the percentage of metal in the ore. The difference in physical or chemical properties of the ore and the impurities determines the procedures used to remove impurities from the ores.
Methods of Concentration of Ore:
- Hand-picking - It was the traditional system of directly concentrating ore with the hands. With the use of a hammer, the gangue or adhering solid matrix is removed from the ore in this procedure. The separation and identification of gangue are based on colour or lump form differences.
- Hydraulic Washing - On passing the ore via an upward stream of water, the lighter gangue particles are separated from the heavier metal ore. This is a gravity separation method.This process is used to enrich ores that are heavier than the gangue particles that are present in them. A stream of water is run through crushed and finely powdered ore in this procedure. Water washes away the lighter gangue particles, leaving the larger ore particles behind.
- Froth Floatation Process - The purpose of this process is to extract gangue from sulfide ores. The ore is pulverized and mixed with water to form a suspension. Collectors and Froth Stabilizers are added to this. Collectors like pine oils, fatty acids, etc. boost the metal part of the ore’s non-wettability, allowing it to form a froth.