An ocean wave of period 8 s and height 2 m is propagating in the Indian Ocean from south to north. According to linear wave theory, for the wave to be considered as a deep-water wave, the minimum water depth should be …………. (rounded off to the nearest integer).
Step 1: Recall the condition for a deep-water wave.
For a wave to be considered a deep-water wave, the water depth \( h \) must satisfy: \[ h \geq \frac{\lambda}{2}, \] where \( \lambda \) is the wavelength of the wave.
Step 2: Determine the wavelength (\( \lambda \)).
Using the wave speed equation: \[ C = \frac{\lambda}{T}, \] where: - \( C \) is the wave speed, - \( T = 8 \, \text{s} \) is the wave period. For deep-water waves, the wave speed \( C \) is given by: \[ C = \sqrt{\frac{g \lambda}{2\pi}}, \] where \( g = 9.81 \, \text{m/s}^2 \) is the acceleration due to gravity. Rewriting the equation: \[ \lambda = \frac{g T^2}{2\pi}. \] Substitute the values: \[ \lambda = \frac{9.81 \cdot 8^2}{2\pi} = \frac{9.81 \cdot 64}{6.2832} = \frac{627.84}{6.2832} \approx 100 \, \text{m}. \] Step 3: Calculate the minimum depth (\( h \)).
Using the deep-water condition: \[ h \geq \frac{\lambda}{2} = \frac{100}{2} = 50 \, \text{m}. \] Conclusion: The minimum water depth for the wave to be considered as a deep-water wave is \( 50 \, \text{m} \).
A steel deck plate of a tanker is supported by two longitudinal stiffeners as shown in the figure. The width of the plate is \( a \) and its length is 5 times the width. Assume that the long edge is simply supported, and the short edge is free. The plate is loaded by a distributed pressure, \( p = p_0 \sin\left(\frac{\pi y}{a}\right) \), where \( p_0 \) is the pressure at \( y = a/2 \). The flexural rigidity of the plate is \( D \). The plate equation is given by
Consider the matrices
\( M = \begin{pmatrix}
2 & 1 \\
0 & 2
\end{pmatrix} \)
\( N = \begin{pmatrix}
1 & 0 & 0 \\
1 & 2 & 0 \\
1 & 1 & 0
\end{pmatrix} \)
Which one of the following is true?
A ship with a standard right-handed coordinate system has positive \(x\), \(y\), and \(z\) axes respectively pointing towards bow, starboard, and down as shown in the figure. If the ship takes a starboard turn, then the drift angle, sway velocity, and the heel angle of the ship for a steady yaw rate respectively are:
A closed system is undergoing a reversible process 1–P–2 from state 1 to 2, as shown in the figure, where X and Y are thermodynamic properties. An irreversible process 2–Q–1 brings the system back from 2 to 1. The net change in entropy of the system and surroundings during the above-mentioned cycle are _______ respectively.
A ship of 3300 tonne displacement is undergoing an inclining experiment in seawater of density 1025 kg/m\(^3\). A mass of 6 tonne is displaced transversely by 12 m as shown in the figure. This results in a 0.12 m deflection of a 11 m long pendulum suspended from the centerline. The transverse metacenter of the ship is located at 7.25 m above the keel.
The distance of the center of gravity from the keel is ________ m (rounded off to two decimal places).
A multi-cell midship section of a ship with \( B = 40 \, {m} \) and \( D = 20 \, {m} \) is shown in the figure. The shear-flows are given as \( q_1 = q_2 = q_3 = 0.9376 \, {MN/m} \). The applied twisting moment on the midship section is ___________ MN·m (rounded off to two decimal places).
Consider a weightless, frictionless piston with a 2 kg mass placed on it as shown in the figure. At equilibrium in position 1, the cylinder contains 0.1 kg of air. The piston cross-sectional area is 0.01 m2. The ambient pressure in the surroundings outside the piston-cylinder arrangement is 0 bar (absolute). When the mass above the piston is removed instantaneously, it moves up and hits the stop at position 2, which is 0.1 m above the initial position.
Assuming \( g = 9.81 \, {m/s}^2 \), the thermodynamic work done by the system during this process is ________ J (answer in integer).