A rough inclined plane $B C E$ of height $\left(\frac{25}{6}\right)\, m$ is kept on a rectangular wooden block $A B C D$ of height $10 m$, as shown in the figure. A small block is allowed to slide down from the top $E$ of the inclined plane. The coefficient of kinetic friction between the block and the inclined plane is $\frac{1}{8}$ and the angle of inclination of the inclined plane is $\sin ^{-1}(0.6)$. If the small block finally reaches the ground at a point $F$, then $D F$ will be (Acceleration due to gravity, $g =10 \,ms ^{-2}$ )
- $\frac{5}{3} m$
- $\frac{10}{3} m$
- $\frac{13}{3} m$
- $\frac{20}{3} m$
The Correct Option is D
Solution and Explanation
Top Questions on Inclined planes
- The moment of inertia of semicircular ring about an axis, passing through the center and perpendicular to the plane of ring, is \(\frac{1}{x} \)MR2 , where R is the radius and M is the mass of semicircular ring. The value of x will be___
- JEE Main - 2023
- Physics
- Inclined planes
Two inclined planes are placed as shown in figure. A block is projected from the point A of inclined plane AB along its surface with a velocity just sufficient to carry it to the top point B at a height 10 m. After reaching the point B the block sides down on inclined plane BC. Time it takes to reach to the point C from point A is t(√2 + 1) s. The value of t is ______.
(Use g = 10 m/s2)
Fig. - JEE Main - 2022
- Physics
- Inclined planes
- A block ‘A’ takes 2 s to slide down a frictionless incline of 30° and length ‘l’, kept inside a lift going up with uniform velocity ‘v’. If the incline is changed to 45°, the time taken by the block, to slide down the incline, will be approximately
- JEE Main - 2022
- Physics
- Inclined planes
- The magnetic flux through a coil perpendicular to its plane is varying according to the relation \(\varphi = 5t^3 + 4t^2 + 2t - 5\) Weber. If the resistance of the coil is 5 ohm, then the induced current through the coil at t = 2 s will be,
- JEE Main - 2022
- Physics
- Inclined planes
- Two blocks $A$ and $B$ of masses $m_A = 1 \; kg$ and $m_B = 3 \; kg$ are kept on the table as shown in figure. The coefficient of friction between $A$ and $B$ is $0.2$ and between $B$ and the surface of the table is also $0.2.$ The maximum force $F$ that can be applied on $B$ horizontally, so that the block $A$ does not slide over the block $B$ is : (Take $g = 10 \; m/s^2$)
- JEE Main - 2019
- Physics
- Inclined planes
Questions Asked in AP EAMCET exam
Six coins tossed simultaneously then find the probability of getting at least 4 heads.
- AP EAMCET - 2023
- Probability
- In the chessboard if the rectangle form is 1296, find the total number of squares formed.
- AP EAMCET - 2023
- Coordinate Geometry
Find the products formed if chlorine reacts with the cold and dilute sodium hydroxide solution.
- AP EAMCET - 2023
- Chemical Reactions
- Find the coefficient of \(\frac{y^3}{x^8}\) in \((x+y)^{-5}\) ?
- AP EAMCET - 2023
- Binomial theorem
- Which compound is gem-dihalide?
- AP EAMCET - 2023
- Organic Chemistry- Some Basic Principles and Techniques
Concepts Used:
Inclined planes
An inclined plane is a simple machine also known as a ramp. It is a simple machine that consists of a sloping surface. Its purpose is to reduce the force that is applied to raise a load. When we need to raise a body vertically, similarly we need to apply a force that is equal to the body’s weight. An incline is like a surface that sets a different angle part from the right one.
Some of the examples of ramps are Roads, vertically, Sloping, wedges, Chisels, Plows, etc.,
Normal Force:
An inclined plane is directed upwards to the opposite direction with the force of gravity, known as the Normal Force. Simply, A normal force is not always directed in the direction that we are accustomed to. But they are not always upwards.
Gravity Force:
The component of the force of gravity is directed opposite to the normal force. It balances the normal force but can’t balance the parallel component of the force of gravity with the help of any other force. It can be resolved into two components- first is directed parallel towards the inclined surfaces, and the other one is directed perpendicular towards the inclined surface.
Read More: Acceleration on Inclined Plane