List of top Metallurgical Engineering Questions

In metal casting, which sprue:runner:gate \emph{area ratio represents a non-pressurized gating system?}
Two randomly oriented polycrystalline copper samples with average grain sizes of 10 \(\mu\)m (Sample A) and 100 \(\mu\)m (Sample B) were tested at room temperature. Let \(E_A, E_B\) be the Young's moduli and \(YS_A, YS_B\) the yield strengths of A and B. Which statement is \emph{correct?}
The coordination number for an octahedral site in pure copper is ____.
Match each crystal defect in Column I with the corresponding type in Column II. Column I:
P. Edge dislocation
Q. Stacking fault
R. Frenkel defect
S. Porosity
Column II:
1. Zero-dimensional defect
2. One-dimensional defect
3. Two-dimensional defect
4. Three-dimensional defect
In LD process, silicon removal takes place before carbon removal since:

Match the following processes with their physical principles:

\(C_p\), the heat capacity at constant pressure is given by:
Back Scattered electrons are used in:
Which of the following is a common defect in wire drawing processes, particularly when excessive friction is present at the die-workpiece interface?
The wax pattern in investment casting is removed by:
What is the relationship between the frequency of the sound waves and the ability to detect smaller defects in Ultrasonic testing?
How brazing is differ from welding?
Which of the following types of penetrant is most commonly used for detecting very fine surface cracks in non-porous materials?
In shell moulding, the binder used to hold the sand grains together is:
Permanent mould casting is best suited for which of the following production areas?
Which of the following is NOT a part of a typical gating system in sand casting?
What is the main problem when welding stainless steels, particularly in the HAZ (Heat-Affected Zone)?
What is the effect of increasing the riser-to-casting volume ratio?
Pourbaix diagrams are graphical plots of ...........
Which of the following is a defect in the rolling process?
Which of the following is the major drawback of using X-rays compared to gamma rays for inspecting thick materials in Radiography Test?
The following technique is most probably recommended for consolidation of nanostructured and amorphous powders:
Fine and spherical powder particles offer poor compressibility and good sinterability. This is due to:
Earing is common defect in:
In cored structure: