List of top Mechanical Engineering Questions asked in Andhra Pradesh Post Graduate Engineering Common Entrance Test

Critical speed of shaft corresponds to:
Whirling speed of a shaft coincide with the natural frequency of the:
The range of projectile is maximum when the angle of projection is:
What is the nature of distribution of shear stress in a rectangular beam?
Pressure in a static fluid:
A purchasing assistant has calculated the carrying cost in Rupees Per unit annum, and the EOQ = 500 units for an item. He must have taken that the annual ordering cost for this item:
Critical damping is a function of
Euler’s theory applies to:
For plane stress, Mohr’s circle has:
A particle moving in a circular path with constant speed has:
In a simply supported beam with a uniform load, the shear force is maximum at:
Which of the following processes is used for shaping metal by pressing it into a mold under high pressure?
Which of the following materials is most suitable for high-temperature applications in gas turbines?
In a turning operation, the cutting speed is 120 m/min, and the diameter of the workpiece is 50 mm. What is the spindle speed in RPM?
If the efficiency of a machine is 80% and it consumes 500 W of power, what is the useful output power?
A Carnot engine operates between a hot reservoir at 800 K and a cold reservoir at 300 K. What is its maximum theoretical efficiency?

A steel workpiece is to be milled. Metal removal rate is 30 cm3/min. Depth of cut is 5 mm and width of cut is 100 mm. The rate of feed in mm/min is}

Which one of the following is the excess of variable time over the activity time when all jobs start as early as possible?
What is the compression ratio of the Otto cycle for a petrol engine with a cylinder bore of 50 mm, a stroke of 75 mm, and clearance volume of 21.3 cm\(^3\)?
In a CNC program block, N130 G02 X65.0 Y60.0 R40.0 F250, G02 refers to
The Non-Destructive Inspection (NDI) technique employed during inspection for castings of tubes and pipes to check the overall strength of a casting in resistance to bursting under hydraulic pressure is:
In Computer Aided Quality Control (CAQC), the coordinate measuring machine

Consider the network diagram shown in Figure. The time estimates in days along the arrows represents the activities. The project completion time in days based on critical path is

A bill of materials is:
Which of the following cannot be used for angular measurements?