List of top Questions asked in Andhra Pradesh Post Graduate Engineering Common Entrance Test

In a short transmission line, voltage regulation is zero only when the load at the receiving end operates at:
The direction of rotation of a DC series motor can be reversed:
(I) By interchanging supply terminals
(II) By interchanging field terminals
A 20KVA, 2000/200 V single-phase transformer has name-plate leakage impedance of 8%. The voltage required to be applied on the HV side to circulate full load current with the LV winding short-circuited will be:
The full load copper-loss and iron-loss of a transformer are 6400 W and 5000 W respectively. The copper-loss and iron-loss at half full-load will be:
A 4kVA, 400V/200V single-phase transformer has resistance of 0.02 pu and reactance of 0.06 pu. The resistance and reactance referred to HV side are:
The purpose of using inter-poles in large DC machines is to nullify:
Which of the following machines run at very low speed (<100 rpm):
When a synchronous motor is operating at normal excitation, its operating power factor is:
Kramer system for controlling the speed of a 3-phase induction motor is mostly used for motors of:
The time system which operates with a continuous time signal and produces a continuous time output signal is:
Find the inverse Fourier transform of \( e^{j2\pi t} \):
The trigonometric Fourier series of an even function of time does not have:
If \( x(t) \) is a causal signal, then for \( t < 0 \):
A DC series motor is accidentally connected to a single-phase AC supply. The torque produced will be:
Ward-Leonard system of speed control is not recommended for:
To implement armature voltage control, it must be ensured that:
Which of the following theorems is the dual of Norton’s theorem?
Heating element of an electric iron is normally made-up of:
If the current density inside a straight conductor is uniform over its cross-section, the flux density variation inside the conductor at different distances from its centre is:
Forced response is the solution of the difference equation when:
Time scaling is an operation performed on:
The system \( y(t) = x(2t) + 3 \) is:

The equivalent resistance between the points X & Y of the circuit shown below is _____ \(\Omega\).

The equivalent resistance
Which of the following can produce maximum induced voltage?
An electric fan and a heater are marked 100W, 220V and 1000W, 220V respectively. The resistance of the heater is ____ .