List of top Physics Questions asked in AIIMS

In Lenz?s law, there is a conversion of
The temperature of the sun is measured with
Which of the following is the infrared wavelength?
A beam of light in air enters into the water. Which of the following characteristics of light will not change?
Conservation of linear momentum is equivalent to
If the mass of a body is $M$ on the surface of the earth, the mass of the same body on the surface of the moon is
Thermocouple thermometer is based on
A nucleus emits one $\alpha$-particle and forms a new nucleus. The mass and charge of the new nucleus is changed in one of the following way
The forces, which meet at one point but their lines of action do not lie in one plane, are called
Light year is a unit of:
The velocity of electromagnetic waves in free space is $3 \times 10^{8} \,m / sec$. The frequency of a radio wave of wave length $150\, m$, is
The H$_{\alpha}$ line of hydrogen
Which of the following is a non-conservative force?
Which of the following is true regarding projectile motion?
Threshold frequency for a metal is $10^{15} Hz$. If the light of wavelength $4000 \mathring {A}$ falls on its surface, then which of the following statement is correct?
The working of a dynamo is based on the principle of
The volume of a gas expands by $0.25 \,m ^{3}$ at a constant pressure of $10^{3} \,N / m$. The work done is equal to
The magnetic flux linked with a coil, in webers, is given by the equation: $\phi=5 t^{2}+3 t+16$. The induced e.m.f. in the coil in the fourth second will be
In general, the wavelength of microwaves, is
Critical temperature can be defined as the temperature
Calorimeters are made of which of the following?
If the radii of circular paths of two particles of same masses are in the ratio $1 : 2$, then to have a constant centripetal force, their velocities should be in a ratio of
Ratio of the amount of heat radiation, transmitted through the body to the amount of heat radiation incident on it, is known as
A galvanometer can be changed into ammeter by providing
Plate current will be maximum, when