List of top Nano Technology Questions asked in Telangana State Post Graduate Engineering Common Entrance Test

Which of the following techniques is primarily used for the synthesis of carbon nanotubes?
Which of the following materials exhibits superparamagnetism at the nanoscale?
The top-down approach in nanofabrication refers to:
The surface area-to-volume ratio of nanoparticles:
Which of the following techniques is most commonly used for imaging at the nanoscale?
The quantum confinement effect in nanoparticles is observed when:
The efficiency of a Carnot engine depends on:
The crystal system characterized by three unequal axes which intersect at 90° is:
The polar moment of inertia of a plane figure about a point is indicative of:
The mass moment of inertia of an object is a measure of:
The study of the motion of bodies without considering the forces that cause the motion is known as:
D’Alembert’s Principle is used to:
In simple harmonic motion (SHM), the force acting on the particle is:
In steady state conduction, the temperature gradient within a solid material does not:
The mode of heat transfer that requires no medium is:
The primary mechanism of heat transfer in furnaces is:
Factors affecting furnace efficiency do not include:
A tool used to visualize energy flow and efficiency in a system is:
The principle of waste heat recovery that involves transferring heat from exhaust gases to the incoming air is:
The difference between recuperators and regenerators is primarily in their:
In recuperators, AMTD refers to:
Salt bath furnaces are used for:
Protective atmospheres in furnaces are used to:
The efficiency of a Carnot cycle is determined by:
The Gibbs-Helmholtz equation is used to determine: