Question:
Which of the following techniques requires timing synchronization between transmitter and receiver?
Which of the following techniques requires timing synchronization between transmitter and receiver?
Updated On: July 22, 2025
- AM
- FM
- FDMA
- TDMA
Hide Solution
Verified By Collegedunia
The Correct Option is D
Solution and Explanation
TDMA (Time Division Multiple Access) divides the channel into time slots,
which require precise timing synchronization between the transmitter and receiver to avoid
data collisions.
Was this answer helpful?
0
0
Top Questions on Communication System
- In the context of intercultural communication, what is 'ethnocentrism'?
- Karnataka PGCET - 2025
- General Awareness
- Communication System
Column-I has statements made by Shanthala; and, Column-II has responses given by Kanishk.
- GATE DA - 2025
- Computer Science
- Communication System
- Communication over a mobile phone is an example of which type of communication mode?
- CUET (UG) - 2024
- Computer Science
- Communication System
- What gets shifted in the signals involved in Frequency Shift Keying?
- AP PGECET - 2024
- Instrumentation Engineering
- Communication System
- In which of the following digital modulation carrier wave switches between 0 and 1 based on applied input?
- AP PGECET - 2024
- Instrumentation Engineering
- Communication System
View More Questions
Questions Asked in TANCET exam
- The faces in a tetragon are
- TANCET - 2024
- Crystallography
- What letter replaces the question mark?
- What is in this sequence? Y, V, S, P, ___
- An intermediate shaft of a gearbox, supporting two spur gears A and B and mounted between two bearings C1 and C2, is shown in the below figure. The pitch circle diameters of gears A and B are 500 and 250 mm respectively. The shaft is made of alloy steel 20MnCr5. (\( S_{ut} = 620 \) and \( S_{yt} = 480 \) N/mm\(^2\)). The factors \( k_b \) and \( k_t \) of the ASME code are 2 and 1.5 respectively. The gears are keyed to the shaft. Determine the shaft diameter using the ASME code.
- TANCET - 2024
- Machine Design
- A train moving at 108 km/hr crosses a platform in 30 seconds. Then it crosses a man running at 12 km/hr in the same direction in 9 seconds. What is the length of train and platform in m?
- TANCET - 2024
- Time, Speed and Distance
View More Questions
TANCET Notification
GMC Azamgarh Admission 2025: Dates, Courses, Fees, Eligibility, SelectJuly 22, 2025GMC Azamgarh Admission 2025