The maximum Polished Rod Load (PRL) in the operation of the sucker rod pump is observed near the:
Show Hint
- top of the stroke and the traveling valve is open.
- top of the stroke and the traveling valve is closed.
- bottom of the stroke and the traveling valve is open.
- bottom of the stroke and the traveling valve is closed.
The Correct Option is B
Solution and Explanation
Step 1: Understanding PRL.
Polished Rod Load is the surface load required to lift the sucker rod string and the fluid column. It varies during the stroke cycle. Step 2: Condition at top of stroke.
At the top of the upstroke: - The rod string is fully stretched, - The entire fluid load is supported, - The traveling valve remains closed (fluid column rests on standing valve). This is when the maximum upward load (PRL) occurs. Step 3: Eliminate other options.
- (A) Incorrect: With valve open, load is shared and less. - (C) Incorrect: At bottom of stroke, rod load is minimum. - (D) Incorrect: At bottom, PRL is not maximum. Final Answer: \[ \boxed{\text{top of the stroke and the traveling valve is closed}} \]
Top Questions on Multiphase Flow
The effect of pressure on various properties of black oil is shown in the figure. The bubble point pressure is \(P_b\).
Which of the following option(s) is/are CORRECT?
- GATE PE - 2025
- Petroleum Production Operations
- Multiphase Flow
- An electrical submersible pump is to be installed to lift oil of \(30^\circ API\) in a 10000 ft deep well. The oil formation volume factor (\(B_o\)) is \(1.25 \, rb/stb\). The desired flow rate is \(8000 \, stb/day\). Minimum suction pressure of the chosen pump is \(200 \, psi\). Inflow performance relationship shows a flowing bottomhole pressure of \(2820 \, psi\) at the desired flow rate. Assuming casing pressure and weight of the gas in the annulus to be negligible, the minimum pump setting depth is \(\underline{\hspace{1cm}} \, ft\) (rounded off to one decimal place).
- GATE PE - 2025
- Petroleum Production Operations
- Multiphase Flow
A production tubing string of length \(1500 \, m\) is tightly held by packers. Production of hot gases increases tubing temperature by \(20^\circ C\). The tubing's Young's modulus is \(3000 \, N/m^2\), and thermal expansion coefficient is \(5 \times 10^{-6} /^\circ C\). The increase in stress due to temperature rise is ______, \( \N/m^2 \) (rounded off to two decimal places).
- GATE PE - 2025
- Petroleum Production Operations
- Multiphase Flow
A Newtonian fluid flows through a smooth horizontal pipe of diameter \(1 \, \text{m}\), length \(1 \, \text{km}\), flow rate \(3.14 \, \text{m}^3/\text{s}\). Viscosity \(\mu = 0.02 \, \mathrm{Pa\cdot s}\), density \(\rho = 800 \, \mathrm{kg/m^3}\). The Darcy friction factor for turbulent flow is: \[ f = \frac{0.316}{Re^{0.25}} \] Find pressure drop due to friction (kPa).
- GATE PE - 2025
- Petroleum Production Operations
- Multiphase Flow
- Natural gas is produced at a flow rate of 2 MMscf/day at the wellhead having temperature and pressure of \(560^\circ R\) and 200 psi, respectively. The apparent molecular weight and compressibility factor (\(z\)) of the gas are estimated to be 20 g/g-mole and 0.8, respectively, at wellhead conditions. The gas formation volume factor (\(B_g\)) at the wellhead condition is ............ \(\times 10^{-2} \, \text{ft}^3/\text{scf}\) (rounded off to one decimal place).
- GATE PE - 2025
- Petroleum Production Operations
- Multiphase Flow
Questions Asked in GATE PE exam
Identify the option that has the most appropriate sequence such that a coherent paragraph is formed:
Statement:
P. At once, without thinking much, people rushed towards the city in hordes with the sole aim of grabbing as much gold as they could.
Q. However, little did they realize about the impending hardships they would have to face on their way to the city: miles of mud, unfriendly forests, hungry beasts, and inimical local lords—all of which would reduce their chances of getting gold to almost zero.
R. All of them thought that easily they could lay their hands on gold and become wealthy overnight.
S. About a hundred years ago, the news that gold had been discovered in Kolar spread like wildfire and the whole State was in raptures.
For a hydrocarbon reservoir, the following parameters are used in the general material balance equation (MBE):
\[ \begin{aligned} N & = \text{Initial (original) oil in place, stb} \\ G & = \text{Initial volume of gas cap, scf} \\ m & = \text{Ratio of initial volume of gas cap to volume of oil initial in place, rb/rb} \\ S_{wi} & = \text{Initial water saturation} \\ S_{oi} & = \text{Initial oil saturation} \\ B_{oi} & = \text{Initial oil formation volume factor, rb/stb} \\ B_{gi} & = \text{Initial gas formation volume factor, rb/scf} \end{aligned} \]
The total pore volume (in rb) of the reservoir is:
- GATE PE - 2025
- Reservoir and channel routing
- The eigenvalues of the matrix \[ A = \begin{bmatrix} 3 & -1 & 1 \\ -1 & 5 & -1 \\ 1 & -1 & 3 \end{bmatrix} \] are \(\lambda_1, \lambda_2, \lambda_3\). The value of \(\lambda_1 \lambda_2 \lambda_3 (\lambda_1 + \lambda_2 + \lambda_3)\) is:
- GATE PE - 2025
- Eigenvalues
A stationary tank is cylindrical in shape with two hemispherical ends and is horizontal, as shown in the figure. \(R\) is the radius of the cylinder as well as of the hemispherical ends. The tank is half filled with an oil of density \(\rho\) and the rest of the space in the tank is occupied by air. The air pressure, inside the tank as well as outside it, is atmospheric. The acceleration due to gravity (\(g\)) acts vertically downward. The net horizontal force applied by the oil on the right hemispherical end (shown by the bold outline in the figure) is:
- GATE PE - 2025
- Integration
- If a function \(f(x)\) is continuous in the closed interval \([a, b]\) and the first derivative \(f'(x)\) exists in the open interval \((a, b)\), then according to the Lagrange's Mean Value Theorem: \[ \frac{f(b) - f(a)}{b - a} = f'(c) \] If \(a = 0, b = 1.5\), and \(f(x) = x(x - 1)(x - 2)\), then the value(s) of \(c\) in \([a, b]\) is/are:
- GATE PE - 2025
- Mean value theorems