Question:
The dimensions of kinematic viscosity are
The dimensions of kinematic viscosity are
Show Hint
Kinematic viscosity is used to characterize the flow of fluids and is important in areas like fluid mechanics and engineering.
Updated On: May 5, 2025
- L\(^2\)T\(^{-1}\)
- L\(^1\)T\(^{-1}\)
- L\(^2\)T\(^{-2}\)
- L\(^1\)T\(^{-2}\)
Hide Solution
Verified By Collegedunia
The Correct Option is A
Solution and Explanation
Kinematic viscosity is defined as the ratio of dynamic viscosity to the fluid's density. Its dimensions are given as L\(^2\)T\(^{-1}\), where L represents length and T represents time.
Was this answer helpful?
0
0
Top Questions on Fluid Mechanics
A flexible chain of mass $m$ is hanging as shown. Find tension at the lowest point.
- JEE Main - 2026
- Physics
- Fluid Mechanics
- Statement-I: Fluid exerts pressure on the surface of a solid in contact with it. Statement-II: The excess potential energy of molecules at the surface of a liquid leads to surface tension. Which of the following is correct?
- JEE Main - 2026
- Physics
- Fluid Mechanics
- Find the volume flow rate in the Venturi meter shown below in which water is flowing. Given that the cross-sectional areas at \(A\) and \(B\) are \(A\) and \(a\) respectively, \[ \frac{A}{a} = 2, A = \sqrt{3}\,\text{m}^2, \] the difference in water levels is \(5\,\text{cm}\) and \(\rho = 1000\,\text{kg m}^{-3}\).
- JEE Main - 2026
- Physics
- Fluid Mechanics
- Find the volume flow rate in the venturi meter given below in which water is flowing.
- JEE Main - 2026
- Physics
- Fluid Mechanics
- Terminal velocity of drop of radius 1 cm is 10 cm/sec. 64 such balls are combined to make a large drop. Find terminal velocity of this larger drop. :
- JEE Main - 2026
- Physics
- Fluid Mechanics
View More Questions
Questions Asked in AP PGECET exam
- The absolute humidity of air at 101.325 kPa is measured to be 0.02 kg of water per kg of dry air. Then the partial pressure of water vapour in the air is:
- AP PGECET - 2025
- Thermodynamics
- If the vapour pressure at two temperatures of a solid phase in equilibrium with its liquid phase is known, then the latent heat of fusion can be calculated by the:
- AP PGECET - 2025
- Thermodynamics
- 1 mole of Argon gas is heated at constant pressure from 200 K to 600 K.
If \( C_p = 4\ \text{cal} \cdot \text{deg}^{-1} \cdot \text{mol}^{-1} \), then the change in entropy will be:
(Given \( \ln 3 = 1.09 \))
- AP PGECET - 2025
- Thermodynamics
- The minimum amount of work required to operate a refrigerator which removes 1000 Cal heat at $0^\circ$C and rejects at $50^\circ$C will be:
- AP PGECET - 2025
- Thermodynamics
- The entropy of single crystalline Silicon at absolute zero will be:
- AP PGECET - 2025
- Thermodynamics
View More Questions