Question:
The catalyst used in the manufacture of polyethylene is a mixture of
The catalyst used in the manufacture of polyethylene is a mixture of
Show Hint
Ziegler-Natta catalysts allow control over polymer stereochemistry during polymerization.
Updated On: May 18, 2025
- Ti, Al(CH$_3$)$_3$
- Ti, CH$_3$MgBr
- TiCl$_3$, Si(CH$_3$)$_4$
- TiCl$_4$, Al(CH$_3$)$_3$
Hide Solution
Verified By Collegedunia
The Correct Option is D
Solution and Explanation
Ziegler-Natta catalyst used for polyethylene production is typically a mixture of titanium compound (like TiCl$_4$) and an organoaluminium compound (like Al(CH$_3$)$_3$).
These provide sites for controlled polymerization of ethylene.
Was this answer helpful?
0
0
Top Questions on Polymers
- A polymer melt being extruded through a spinneret hole of circular cross-section exhibits a die-swell ratio of 2.2. The extrusion velocity and volumetric flow rate during this extrusion process are 20 m/min and \(2.6 \times 10^{-8}\) m\(^3\)/s, respectively. The maximum diameter (mm) of the extruded melt after exit from the spinneret hole (rounded off to 2 decimal places) is:
- The main constituent of vinegar is:
- The monomer of natural rubber is:
- The catalyst used in the preparation of high density polythene is
- Arrange the following polymers in increasing order of intermolecular forces:
View More Questions
Questions Asked in AP EAPCET exam
- In a series LCR circuit, the voltages across the capacitor, resistor, and inductor are in the ratio 2:3:6. If the voltage of the source in the circuit is 240 V, then the voltage across the inductor is
- AP EAPCET - 2025
- Electromagnetic induction
- 0.25 moles of $ \text{CH}_2\text{FCOOH} $ was dissolved in $ 0.5 \, \text{kg} $ of water. The depression in freezing point of the resultant solution was observed as $ 1^\circ \text{C} $. What is the van't Hoff factor? ($ K_f = 1.86 \, \text{K kg mol}^{-1} $)
- AP EAPCET - 2025
- Colligative Properties
- At $T(K)$, the vapor pressure of water is $x$ kPa. What is the vapor pressure (in kPa) of 1 molal solution containing non-volatile solute?
- AP EAPCET - 2025
- Colligative Properties
- At 300 K, vapour pressure of pure liquid A is 70 mm Hg. It forms an ideal solution with liquid B. Mole fraction of B = 0.2 and total vapour pressure of solution = 84 mm Hg. What is vapour pressure (in mm) of pure B?
- AP EAPCET - 2025
- Colligative Properties
- A 1% (w/v) aqueous solution of a certain solute is isotonic with a 3% (w/v) solution of glucose (molar mass 180 g mol$^{-1}$). The molar mass of solute (in g mol$^{-1}$) is
- AP EAPCET - 2025
- Colligative Properties
View More Questions