>
Exams
>
Automobile Engineering
>
Alternate Fuels
>
micro explosion occurs at the temperature of about
Question:
Micro explosion occurs at the temperature of about:
Show Hint
Understanding the combustion temperatures can aid in designing safer and more efficient engine systems.
TANCET - 2024
TANCET
Updated On:
Feb 7, 2025
100°C
200°C
300°C
400°C
Hide Solution
Verified By Collegedunia
The Correct Option is
D
Solution and Explanation
Micro explosions in engine processes typically occur at higher temperatures, around 400°C, where fuel vaporizes rapidly leading to explosive combustion.
Download Solution in PDF
Was this answer helpful?
0
0
Top Questions on Alternate Fuels
Hydrogen Induction in diesel engine will:
TANCET - 2024
Automobile Engineering
Alternate Fuels
View Solution
Hydrogen combustion with air at stoichiometric condition results in:
TANCET - 2024
Automobile Engineering
Alternate Fuels
View Solution
Biogas is:
TANCET - 2024
Automobile Engineering
Alternate Fuels
View Solution
Which of the following is not a stage of combustion in an SI engine?
TANCET - 2024
Automobile Engineering
Alternate Fuels
View Solution
The self-ignition Temperature of Methanol is:
TANCET - 2024
Automobile Engineering
Alternate Fuels
View Solution
View More Questions
Questions Asked in TANCET exam
The centrifugal force (N) acting on a material mass 2g present at the tip of a beater of radius 25 cm rotating at 600 rpm is
TANCET - 2024
Yarn Engineering
View Solution
Select the correct match
TANCET - 2024
Yarn Engineering
View Solution
Two yarns of count X each are doubled and plied. The ratio of resultant count of two ply yarn expressed in tex system and Ne system is_______. Neglect contraction due to twist.
TANCET - 2024
Yarn Engineering
View Solution
A reed has 15 dents/cm, and the warp is drawn in two ends per dent. If the finished fabric is 1.4 m wide compared with 1.47 m wide in the reed, what is the finished fabric sett?
TANCET - 2024
Fabric Engineering
View Solution
Among the following systems of drafting, the objective of which is to reduce the friction between adjacent warp ends?
TANCET - 2024
Fabric Engineering
View Solution
View More Questions