Question:
Kirkbride equation is used for determining the —————.
Kirkbride equation is used for determining the —————.
Show Hint
Proper feed tray location ensures efficient separation in distillation columns.
Updated On: June 02, 2025
- \( R_{{min}} \)
- \( N_{{min}} \)
- \( N_{{opt}} \)
- Feed tray location
Hide Solution
Verified By Collegedunia
The Correct Option is D
Solution and Explanation
- The Kirkbride equation is used to determine the optimum feed tray location in distillation columns by balancing vapor and liquid flows. Conclusion:
The correct answer is option (D).
Was this answer helpful?
0
0
Top Questions on Adsorption
- Adsorption of phenol from its aqueous solution on to fly ash obeys Freundlich isotherm. At a given temperature, from 10 mg g$^{-1}$ and 16 mg g$^{-1}$ aqueous phenol solutions, the concentrations of adsorbed phenol are measured to be 4 mg g$^{-1}$ and 10 mg g$^{-1}$, respectively. At this temperature, the concentration (in mg g$^{-1}$) of adsorbed phenol from 20 mg g$^{-1}$ aqueous solution of phenol will be ____. Use: $\log_{10} 2 = 0.3$
- 500 mg of a dry adsorbent is added to a beaker containing 100 mL solution of concentration 100 mg phenol/(L solution). The adsorbent is separated out after 5 h of rigorous mixing. If the residual concentration in the solution after separating the adsorbent is 30 mg phenol/(L solution), the amount of phenol adsorbed (in mg per gram of dry adsorbent) is:
- GATE CH - 2025
- Heat Transfer
- Adsorption
- Which term from the following is not related to adsorption?
- CUET (UG) - 2024
- Chemistry
- Adsorption
- Which of the following can adsorb larger volume of hydrogen gas?
- Which of the following happens in the use of Raschig rings in place of crushed stones as packing in packed beds (other things being same)?
View More Questions
Questions Asked in TANCET exam
- What letter replaces the question mark?
- An intermediate shaft of a gearbox, supporting two spur gears A and B and mounted between two bearings C1 and C2, is shown in the below figure. The pitch circle diameters of gears A and B are 500 and 250 mm respectively. The shaft is made of alloy steel 20MnCr5. (\( S_{ut} = 620 \) and \( S_{yt} = 480 \) N/mm\(^2\)). The factors \( k_b \) and \( k_t \) of the ASME code are 2 and 1.5 respectively. The gears are keyed to the shaft. Determine the shaft diameter using the ASME code.
- TANCET - 2024
- Machine Design
- A train moving at 108 km/hr crosses a platform in 30 seconds. Then it crosses a man running at 12 km/hr in the same direction in 9 seconds. What is the length of train and platform in m?
- TANCET - 2024
- Time, Speed and Distance
- The speed of a motor boat in still water is 7km/hr. If the speed of the motor boat against the stream is 5 km/hr, what is the speed of the stream?
- TANCET - 2024
- Time, Speed and Distance
A closed-loop system has the characteristic equation given by: $ s^3 + k s^2 + (k+2) s + 3 = 0 $.
For the system to be stable, the value of $ k $ is:- TANCET - 2024
- Microprocessors
View More Questions
