Question:
In which polymer preparation, Ziegler–Natta catalyst is used?
In which polymer preparation, Ziegler–Natta catalyst is used?
Show Hint
Ziegler–Natta catalysts are mainly used in the production of HDPE and polypropylene.
Updated On: Jun 4, 2025
- Low density polythene
- Teflon
- Polyacrylonitrile
- High density polythene
Hide Solution
Verified By Collegedunia
The Correct Option is D
Solution and Explanation
Ziegler–Natta catalysts are used for the polymerization of ethene to form high density polythene (HDPE). These catalysts enable polymerization under milder conditions and provide better control over the polymer structure.
Was this answer helpful?
0
0
Top Questions on Polymers
- A polymer melt being extruded through a spinneret hole of circular cross-section exhibits a die-swell ratio of 2.2. The extrusion velocity and volumetric flow rate during this extrusion process are 20 m/min and \(2.6 \times 10^{-8}\) m\(^3\)/s, respectively. The maximum diameter (mm) of the extruded melt after exit from the spinneret hole (rounded off to 2 decimal places) is:
- The main constituent of vinegar is:
- The monomer of natural rubber is:
- The catalyst used in the preparation of high density polythene is
- Arrange the following polymers in increasing order of intermolecular forces:
View More Questions
Questions Asked in AP EAPCET exam
- In a series LCR circuit, the voltages across the capacitor, resistor, and inductor are in the ratio 2:3:6. If the voltage of the source in the circuit is 240 V, then the voltage across the inductor is
- AP EAPCET - 2025
- Electromagnetic induction
- 0.25 moles of $ \text{CH}_2\text{FCOOH} $ was dissolved in $ 0.5 \, \text{kg} $ of water. The depression in freezing point of the resultant solution was observed as $ 1^\circ \text{C} $. What is the van't Hoff factor? ($ K_f = 1.86 \, \text{K kg mol}^{-1} $)
- AP EAPCET - 2025
- Colligative Properties
- At $T(K)$, the vapor pressure of water is $x$ kPa. What is the vapor pressure (in kPa) of 1 molal solution containing non-volatile solute?
- AP EAPCET - 2025
- Colligative Properties
- At 300 K, vapour pressure of pure liquid A is 70 mm Hg. It forms an ideal solution with liquid B. Mole fraction of B = 0.2 and total vapour pressure of solution = 84 mm Hg. What is vapour pressure (in mm) of pure B?
- AP EAPCET - 2025
- Colligative Properties
- A 1% (w/v) aqueous solution of a certain solute is isotonic with a 3% (w/v) solution of glucose (molar mass 180 g mol$^{-1}$). The molar mass of solute (in g mol$^{-1}$) is
- AP EAPCET - 2025
- Colligative Properties
View More Questions