For the circuit shown in the figure, the active power supplied by the source is ________ W (rounded off to one decimal place).
A signal $V_M = 5\sin(\pi t/3) V$ is applied to the circuit consisting of a switch S and capacitor $C = 0.1 \mu F$, as shown in the figure. The output $V_x$ of the circuit is fed to an ADC having an input impedance consisting of a $10 M\Omega$ resistance in parallel with a $0.1 \mu F$ capacitor. If S is opened at $t = 0.5 s$, the value of $V_x$ at $t = 1.5 s$ will be ________ V (rounded off to two decimal places).
Note: Assume all components are ideal.
In the circuit shown, the switch is opened at $t = 0$ s. The current $i(t)$ at $t = 2$ ms is ________ mA (rounded off to two decimal places).
In the circuit shown, the galvanometer (G) has an internal resistance of $100 \Omega$. The galvanometer current $I_G$ is ________ $\mu A$ (rounded off to the nearest integer).
The circuit given in the figure is driven by a voltage source $V_s = 25\sqrt{2}\angle 30^\circ V$. The system is operating at a frequency of 50 Hz. The transformers are assumed to be ideal. The average power dissipated, in W, in the $50 k\Omega$ resistance is ________ (rounded off to two decimal places).
A feedback control system is shown in the figure.
The maximum allowable value of \( n \) such that the output \( y(t) \), due to any step disturbance signal \( d(t) \), becomes zero at steady-state, is ________ (in integer).
An air filled parallel plate electrostatic actuator is shown in the figure. The area of each capacitor plate is $100 \mu m \times 100 \mu m$. The distance between the plates $d_0 = 1 \mu m$ when both the capacitor charge and spring restoring force are zero as shown in Figure (a). A linear spring of constant $k = 0.01 N/m$ is connected to the movable plate. When charge is supplied to the capacitor using a current source, the top plate moves as shown in Figure (b). The magnitude of minimum charge (Q) required to momentarily close the gap between the plates is ________ $\times 10^{-14}$ C (rounded off to two decimal places).
Note: Assume a full range of motion is possible for the top plate and there is no fringe capacitance. The permittivity of free space is $\epsilon_0 = 8.85 \times 10^{-12}$ F/m and relative permittivity of air ($\epsilon_r$) is 1.
A schematic of a Michelson interferometer, used for the measurement of refractive index of gas, is shown in the figure. The transparent chamber is filled with a gas of refractive index $n_g$, where $n_g \neq 1$, at atmospheric pressure. If a 532 nm laser beam produces 30 interference fringes on the screen, then the number of fringes produced by a 632.8 nm laser beam will be ________ (rounded off to one decimal place). Note: Assume that the effect of beamsplitter width is negligible. The setup is placed in air medium with refractive index equal to 1.