Question:
Favorable condition for product formation in the given reaction.
SO2 + ½O2 → SO3 (g)
Favorable condition for product formation in the given reaction.
SO2 + ½O2 → SO3 (g)
SO2 + ½O2 → SO3 (g)
Updated On: Jun 21, 2024
- High pressure
- High temperature & low pressure
- Low temperature & high pressure
- Low temperature & low pressure
Hide Solution
Verified By Collegedunia
The Correct Option is A
Solution and Explanation
The correct option is (A): High pressure.
Was this answer helpful?
0
0
Top Questions on Ionic Equilibrium
- In a conductometric titration, small volume of titrant of higher concentration is added stepwise to a larger volume of titrate of much lower concentration, and the conductance is measured after each addition.
The limiting ionic conductivity (Λ0) values (in mS m2mol−1 ) for different ions in aqueous solutions are given below:
For different combinations of titrates and titrants given in List-I, the graphs of 'conductance' versus ‘volume of titrant’ are given in List-II.Ions Ag+ K+ Na+ H+ \(\text{NO}_{3}^{-}\) Cl- \(\text{SO}^{2-}_{4}\) OH- CH3COO- \(\Lambda_0\) 6.2 7.4 5.0 35.0 7.2 7.6 16.0 19.9 4.1
Match each entry in List-I with the appropriate entry in List-II and choose the correct option.
List I
List II
(P) Titrate: KCl
Titrant: AgNO3(1) 
(Q) Titrate: AgNO3
Titrant: KCl(2) 
(R) Titrate: NaOH
Titrant: HCl(3) 
(S) Titrate: NaOH
Titrant: CH3COOH(4) 
(5) 
- JEE Advanced - 2024
- Chemistry
- Ionic Equilibrium
- Find out the degree of dissociation of HF in 1 M aqueous solution. The value of K for the ionic equilibrium \(HF ⇌ H^++F^-\; is \;7.2 × 10^{-4.}\)
- CUET (PG) - 2023
- Chemistry
- Ionic Equilibrium
- Match the symbols in the List I with the terms used in the List II of conductance measurements, and
List I
SymbolsList II
TermsA \(\Omega^{-1}\) I Specific conductance B \(∧\) II Electrical conductance C k III Specific resistance D \(\rho\) IV Equivalent conductance
Choose the correct answer from the options given below:- GPAT - 2022
- Pharmaceutical Chemistry
- Ionic Equilibrium
- Stability index, determined for evaluating the stability of oil–water viscous emulsions, based on electric conductivity changes during non‐destructive short heating–cooling–heating cycles,
A. is defined as \(\frac{Δ}{h}\), where h is the change in the conductivity between 35°C and 45°C and Δ is the conductivity interval within the two heating curves at 35°C
B. indicates the relative change in enthalpy between two cycles
C. is defined as \(\frac{2Δ}{h}\), where h is the change in the conductivity between 35°C and 45°C and Δ is the conductivity interval within the two heating curves at 35°C
D. indicates the relative change in conductivity between two cycles
Choose the correct answer from the options given below:- GPAT - 2022
- Physical Chemistry
- Ionic Equilibrium
- Which among the following cations has the lowest molar ionic conductivity in water at infinite dilution and at 25 degree centigrade?
- GPAT - 2021
- Physical Chemistry
- Ionic Equilibrium
View More Questions
Questions Asked in JIPMER MBBS exam
- If same charge q is placed inside a sphere and cube having radius 1m and side 2m respectively. What will be the ratio of flux passing through them ?
- JIPMER MBBS - 2019
- Electric Flux
- \(BrO^{3-}\) Changes into \(Br_2\) in an acidic medium of a unbalanced equation how many electron should be present on the balanced electron.
- JIPMER MBBS - 2019
- Balancing a redox reaction
- If resistivity of copper is \(1.72×10^{-8} \Omega-m\) and number of free electron in copper is \(8.5×10^{28} / m^3\). Find mobility
- JIPMER MBBS - 2019
- Resistance and Resistivity
- If equilibrium constant is 2.6×108 then find the value of ΔG°.
- JIPMER MBBS - 2019
- Thermodynamics
- Level of LH is maximum :
- JIPMER MBBS - 2019
- Hormones
View More Questions