0.5
The power factor \( \cos(\phi) \) is given by: \[ \cos(\phi) = \frac{R}{Z} \] where \( Z = \sqrt{R^2 + X_C^2} \). Given \( \frac{X_C}{R} = \frac{4}{3} \), we find: \[ Z = R \sqrt{1 + \left(\frac{4}{3}\right)^2} = R \sqrt{1 + \frac{16}{9}} = R \sqrt{\frac{25}{9}} = \frac{5R}{3} \] Thus, \( \cos(\phi) = \frac{R}{\frac{5R}{3}} = 0.6 \).
A Wheatstone bridge is initially at room temperature and all arms of the bridge have same value of resistances \[ (R_1=R_2=R_3=R_4). \] When \(R_3\) resistance is heated, its resistance value increases by \(10%\). The potential difference \((V_a-V_b)\) after \(R_3\) is heated is _______ V. 
The heat generated in 1 minute between points A and B in the given circuit, when a battery of 9 V with internal resistance of 1 \(\Omega\) is connected across these points is ______ J. 
The following diagram shows a Zener diode as a voltage regulator. The Zener diode is rated at \(V_z = 5\) V and the desired current in load is 5 mA. The unregulated voltage source can supply up to 25 V. Considering the Zener diode can withstand four times of the load current, the value of resistor \(R_s\) (shown in circuit) should be_______ \(\Omega\).
An object is projected with kinetic energy K from point A at an angle 60° with the horizontal. The ratio of the difference in kinetic energies at points B and C to that at point A (see figure), in the absence of air friction is : 