List of top Instrumentation Engineering Questions

Cavitation in a control valve is caused by:
A dead weight tester is used for:
Hot wire anemometer is used to measure:
Load cells are used for measurement of:
The electrical output down a thermocouple circuit is detected by using:
Which of the following is the best method for determining the stability and transient response?
The internal resistance of armature should ideally be:
In majority of instruments damping is provided by:
An ideal op-amp has CMRR:
If the characteristic equation of a closed-loop system is $s^2 + 2s + 2 = 0$, then the system is:
The type denotes the number of:
What determines the light intensity in a CRT?
The Bode plot of the transfer function $G(s) = 5$ is:
Which of the following controller produces zero offset?
What is the vector address of RST 6.5 interrupt?
The binary representation of the decimal number 1.375 is
The number of hardware interrupts (which require an external signal to interrupt) present in an 8085 microprocessor are:
How many special function registers are there in 8051 microcontroller?
What decides the bit size of 8085 microprocessor?
What is the maximum addressing capacity of 8085 microprocessor?
Which of the following logics possesses highest noise immunity?
A $100\ \Omega$, 1 W resistor and a $800\ \Omega$, 2 W resistor are connected in series. The maximum DC voltage that can be applied continuously to the series circuit without exceeding the power limit of any of the resistors is:
For increasing the range of voltmeter, connect a:
A dual-trace CRO has:
In a permanent magnet moving coil instrument, if the control spring is replaced by another one having a higher spring constant, then the natural frequency and damping ratio will: