List of top Fashion Studies Questions

Which of the following considerations should be kept in mind while selecting interfacing for a garment?
(A) Interfacing fabric should overpower garment fabric.
(B) Interfacing should complement and reinforce garment fabric.
(C) Fabric for interfacing and garment need not to be identical but have some care requirements.
(D) Fabric for interfacing and garment must be identical but should have different care requirements.
The facing strip used to finish a round neckline is cut:
Who was the first designer to use studs as a mean of reinforcing the seams on workpants?
A two-piece garment worn with a shirt:
The process of pulling ‘off-grain’ fabric diagonally at the opposite ends to make it ‘on-grain’ is known as:
The ‘Measurement method’ used to convert a two-dart skirt into one dart, can also be used in:
The belief that certain parts of animals like claws, hooves, and teeth worn as accessories enhanced the wearer’s strength, stems from which of the factors affecting clothing?
Which of the following results in deviation of grainline/creating off-grain garment?
(A) Incorrect cutting of fabric.
(B) Incorrect stitching.
(C) Insufficient ease in the garment.
(D) Poor posture/figure irregularities.
Which of the following fabrics have the tendency to wrinkle?
Which of the following factors influence the sizing system for women?
(A) Bust width
(B) Hip girth
(C) Height of the wearer
(D) Length of the sleeve
Who among the following defined Fashion as ‘Prevailing custom, usage or style’?
This is used for pattern development where seam allowances are calculated at the time of cutting the final pattern.
Which of the following is NOT a directional fabric?
Arrange the following steps to straighten a slightly off-grain fabric in the correct order.
(A) Fold the fabric lengthwise.
(B) Pin the selvedges together.
(C) Lay the fabric flat.
(D) Iron from the selvedges to the fold.
For garments to be cut on a straight grain, the grainline is drawn:
Match List-I with List-II:
List-I (Trims)List-II (Examples)
(A) Lacings(I) Lettuce Edge
(B) Linear Trims(II) Buckles and Locks
(C) Hardwares(III) Spaghetti Straps
(D) Shaped Edges(IV) Corded Seam
Choose the correct answer from the options given below:
Which of the following is used to finish the raw edges of fabric?
Match List-I with List-II:
List-I (Pret Label)List-II (Designer)
(A) DKNY(I) Prada
(B) Pleats Please(II) Ritu Kumar
(C) Miu Miu(III) Donna Karan
(D) Label(IV) Issey Miyake
Choose the correct answer from the options given below:
Which of the following is a registered trademark of ‘Acrylic’ used by some companies:
Match List-I with List-II:
List-I (Fitting Problems)List-II (Reasons)
(A) Neckline doesn’t lie flat against body(I) Shoulders are too narrow
(B) Collar is too tight(II) Circumference of sleeve is tight
(C) Sleeves pull across the upper arm and cause wrinkles(III) No difference between neck and collar measurement
(D) Sleeves bind and has wrinkles horizontally across the arm(IV) Too large neckline
Choose the correct answer from the options given below:
Match List-I with List-II:
List-I (Identification Mark)List-II (Identification Type)
(A) Restrictive sumptuary laws(I) Identification of profession
(B) Wedding band on ring finger(II) Identification of marital status
(C) Robes and wigs of judges(III) Identification of individual status in a tribe
(D) Special clothes, mask, and carrier accessories(IV) Identification of social status
Choose the correct answer from the options given below:
Which of the following lines passes through the apex?
Which of the following is NOT true about dart manipulation?
The method in which two-dimensional fabric is made to fit on the dress form to achieve desired look:
In which decade was the ‘Fashion Design Council of India’ established?