List of top Textile Engineering and Fibre Science Questions asked in Telangana State Post Graduate Engineering Common Entrance Test

Warp stop motion is not found in
The percentage stretch employed in sizing of 2/40's P/V yarn meant for unconventional weaving is about
Friction let off in modern loom is of type.
Which of the following drafts is used for production of plain weave in industry?

If projectile gripper, rapier & air jet weaving are compared for techno-economic aspects, one can say that

The general rule of drawing order of ends in a Reed for any weave is

Match Group I with Group II and choose the correct options

Maximum machine diameter for circular weft knit machine is
Fancy matty is the result of
Pattern depth depends on
The maximum yarn tension build up occurs in
Tightness factor is given by
Rack means

As compared to woven fabrics, the values of G, HB & 2 HG in knit goods are

The following has excellent elastic recovery
Which of the following governs the Run-in Ratio in warp knitting?
Use of scrambler roller in condenser card gives
In needle punching, the DPN, ND and WW will influence
In Needle punching a Crown needle has ......... number of barbs
In a cross lapper, if draw off speed is V$_A$ and laying speed is V$_L$, then laying angle is given by
Two x Two Rubia cloth needs
One bath dyeing of P/C blends calls for use of
The capacity of a processing unit is normally judged by the number of
Quality of the fabric finished in stenter basically depends on
The best dyeing uniformity is obtained on