A spontaneous reaction will undoubtedly occur in a chemical process that is exothermic and has an escalating disorder.
H is negative because the process is exothermic. S is positive since the illness is becoming worse.
\(\triangle\)G= \(\triangle\)H−T\(\triangle\)S =−ve−(+ve×+ve)=−ve
G has a negative value, which is consistent with spontaneous process.
Therefore, the correct option is (C): Exothermic and increasing disorder
The standard heat of formation, in kcal/mol, of $Ba^{2+}$ is:
Given: Standard heat of formation of SO₄²⁻(aq) = -216 kcal/mol, standard heat of crystallization of BaSO₄(s) = -4.5 kcal/mol, standard heat of formation of BaSO₄(s) = -349 kcal/mol.
A stream of superheated steam (2 MPa, 300°C) mixes with another stream of superheated steam (2 MPa, 400°C) through a steady-state adiabatic process. The flow rates of the streams are 3 kg/min and 2 kg/min, respectively. This mixture then expands in an adiabatic nozzle to a saturated mixture with quality of 0.77 and 1 kPa. Neglect the velocity at the nozzle entrance and the change in potential energies. The velocity at the nozzle exit (in m/s) is ......... (rounded off to two decimal places).
Use the following data:
At 2 MPa, 300 °C: Specific enthalpy of superheated steam = 3024.2 kJ/kg
At 2 MPa, 400 °C: Specific enthalpy of superheated steam = 3248.4 kJ/kg
At 1 kPa: Specific enthalpy of saturated water = 29.3 kJ/kg
At 1 kPa: Specific enthalpy of saturated vapour = 2513.7 kJ/kg
The current passing through the battery in the given circuit, is:
Three identical heat conducting rods are connected in series as shown in the figure. The rods on the sides have thermal conductivity 2K while that in the middle has thermal conductivity K. The left end of the combination is maintained at temperature 3T and the right end at T. The rods are thermally insulated from outside. In steady state, temperature at the left junction is \(T_1\) and that at the right junction is \(T_2\). The ratio \(T_1 / T_2\) is
Spontaneity comes under the First Law of Thermodynamics that is based on the law of conservation of energy which explains that energy can be transformed from one form to another but cannot be created or destroyed. The spontaneity in thermodynamics defines the direction of heat flow that can be developed by establishing a relationship between the work done by the system or by the system. All of the processes of heat flow which happen naturally tend to proceed spontaneously only in one direction.
A spontaneous chemical reaction is an irreversible process where you can’t get the ingredients back without the external agents.
Total entropy change is the essential parameter that defines the spontaneity of any process. Since most of the chemical reactions fall under the category of a closed system and open system; we can say there is a change in enthalpy too along with the change in entropy. Since, change in enthalpy also increases or decreases the randomness by affecting the molecular motions, entropy change alone cannot account for the spontaneity of such a process. Therefore, for explaining the spontaneity of a process we use the Gibbs energy change. Gibbs’ energy is a state function and an extensive property. The general expression for Gibbs energy change at constant temperature is expressed as:
ΔGsys = ΔHsys – TΔSsys
Here,
Change in Gibbs energy of the system = ΔGsys
Change in enthalpy of the system = ΔHsys
Change in Entropy of the system = ΔSsys
Constant Temperature of the system = T
Also, if we conduct a spontaneous process, the total change in entropy is always greater than zero.
Mathematical expression for the above spontaneous reaction meaning expression is
ΔSsys + ΔSsurr = ΔStotal
Here,
ΔStotal = total change in entropy for the process
ΔSsurr = change in entropy of the surrounding
ΔSsys = change in entropy of the system
Also, for a spontaneous process, the total change in entropy is 0, i.e. ΔStotal> 0.
Therefore;
TΔSsys – ΔHsys>0
ΔHsys– TΔSsys<0
Using the Gibbs equation, it can be said that
ΔGsys< 0
Thus, it can be inferred that any process is spontaneous if the change in Gibbs energy of the system is less than zero or else the process is not spontaneous.
This by the already provided equations the spontaneity can be predicted.