Question:
Which of the following options does not belong to a special purpose lathe?
Which of the following options does not belong to a special purpose lathe?
Show Hint
When selecting a lathe, choose a special-purpose lathe for specific tasks such as wheel turning or crankshaft turning to maximize efficiency.
Updated On: Feb 10, 2025
- Wheel lathe
- Gap bed lathe
- Crank shaft lathe
- Rear edge lathe
Hide Solution
Verified By Collegedunia
The Correct Option is B
Solution and Explanation
A gap bed lathe is a general-purpose lathe that features a removable section of the bed to accommodate larger workpieces. It is not a special-purpose lathe like a wheel lathe, crankshaft lathe, or rear edge lathe, which are designed for specific tasks.
Was this answer helpful?
0
0
Top Questions on Production Technology
- Identify the correct type of defect for casting shown below:
- TANCET - 2024
- Mechanical Engineering
- Production Technology
- In a machining operation that approximates orthogonal cutting, the cutting tool has a rake angle of 10°. The chip thickness before the cut \(t_0 = 0.50\) mm and the chip thickness after the cut \(t_c = 1.125\) mm. The shear plane angle \(\phi\) is ——–––––––––.
Assuming \(\sin 10^\circ = 0.173\) and \(\cos 10^\circ = 0.984\).- TANCET - 2024
- Mechanical Engineering
- Production Technology
- Identify the operation related to drilling which is illustrated in Figure below.
- TANCET - 2024
- Mechanical Engineering
- Production Technology
- Which of the following is an incorrect operation in relation to the finishing processes employed for gear teeth?
- TANCET - 2024
- Mechanical Engineering
- Production Technology
- In laser beam welding, ——––––––––– are associated with the evolution of vapor from the surface of the material to produce a needle-like, vapor-filled cavity or keyhole in the work piece through which the beam can penetrate.
- TANCET - 2024
- Mechanical Engineering
- Production Technology
View More Questions
Questions Asked in TANCET exam
- The centrifugal force (N) acting on a material mass 2g present at the tip of a beater of radius 25 cm rotating at 600 rpm is
- TANCET - 2024
- Yarn Engineering
- Select the correct match
- TANCET - 2024
- Yarn Engineering
- Two yarns of count X each are doubled and plied. The ratio of resultant count of two ply yarn expressed in tex system and Ne system is_______. Neglect contraction due to twist.
- TANCET - 2024
- Yarn Engineering
- A reed has 15 dents/cm, and the warp is drawn in two ends per dent. If the finished fabric is 1.4 m wide compared with 1.47 m wide in the reed, what is the finished fabric sett?
- TANCET - 2024
- Fabric Engineering
- Among the following systems of drafting, the objective of which is to reduce the friction between adjacent warp ends?
- TANCET - 2024
- Fabric Engineering
View More Questions