Question:
Which of the following is the longitudinal framing of the roof at the joining?
Which of the following is the longitudinal framing of the roof at the joining?
Show Hint
The cant rail is essential in car body design for adding strength to the vehicle's roof structure and aiding in the mounting of interior and exterior trim.
Updated On: Feb 7, 2025
- Cant panel
- Cant rail
- Cowl panel
- Drip rail
Hide Solution
Verified By Collegedunia
The Correct Option is B
Solution and Explanation
The cant rail is a component in vehicle construction that serves as the longitudinal framing at the roof’s edge, providing structural integrity and attachment points for various components.
Was this answer helpful?
0
0
Top Questions on Vehicle Body Engineering
- Solar radiation is increased inside the passenger compartment by increasing __________ of a car.
- TANCET - 2024
- Automobile Engineering
- Vehicle Body Engineering
- In a wind tunnel, the honeycomb has a longer length that reduces the ______ velocity components of the flow with minimal pressure drop in the stream wise direction.
- TANCET - 2024
- Automobile Engineering
- Vehicle Body Engineering
- As per AIS 052, School Bus are come under the TYPE
- TANCET - 2024
- Automobile Engineering
- Vehicle Body Engineering
- The vehicle having a passenger cabin with two rows of seats and integrated cargo space, accessed from behind by a single tail gate is:
- TANCET - 2024
- Automobile Engineering
- Vehicle Body Engineering
Questions Asked in TANCET exam
- The centrifugal force (N) acting on a material mass 2g present at the tip of a beater of radius 25 cm rotating at 600 rpm is
- TANCET - 2024
- Yarn Engineering
- Select the correct match
- TANCET - 2024
- Yarn Engineering
- Two yarns of count X each are doubled and plied. The ratio of resultant count of two ply yarn expressed in tex system and Ne system is_______. Neglect contraction due to twist.
- TANCET - 2024
- Yarn Engineering
- A reed has 15 dents/cm, and the warp is drawn in two ends per dent. If the finished fabric is 1.4 m wide compared with 1.47 m wide in the reed, what is the finished fabric sett?
- TANCET - 2024
- Fabric Engineering
- Among the following systems of drafting, the objective of which is to reduce the friction between adjacent warp ends?
- TANCET - 2024
- Fabric Engineering
View More Questions