Question:
Which of the following is an incorrect operation in relation to the finishing processes employed for gear teeth?
Which of the following is an incorrect operation in relation to the finishing processes employed for gear teeth?
Show Hint
Burnishing is a polishing process typically used to improve surface finish, but it is not commonly used for finishing gear teeth.
Updated On: July 22, 2025
- Gear trimming
- Gear shaving
- Gear grinding
- Burnishing
Hide Solution
Verified By Collegedunia
The Correct Option is D
Solution and Explanation
Burnishing is typically not used as a finishing process for gear teeth. The common finishing processes for gear teeth include gear trimming, shaving, and grinding, all of which help to improve the accuracy and smoothness of the gear teeth.
Was this answer helpful?
0
0
Top Questions on Production Technology
- Nose radius is expressed in:
- TANCET - 2024
- Automobile Engineering
- Production Technology
- Match list I with list II and select the correct answer using the code given:
- TANCET - 2024
- Automobile Engineering
- Production Technology
- Consider the following statements about non-conventional machining processes:
i. Hard materials can be easily machined without being damaged
ii. Complex shapes are easily produced
iii. They have low specific energy consumption
iv. Tools need not be harder than work piece- TANCET - 2024
- Automobile Engineering
- Production Technology
- Match list I with list II and select the correct answer using the code given:
- TANCET - 2024
- Automobile Engineering
- Production Technology
- Match list I with list II and select the correct answer using the code given:
- TANCET - 2024
- Automobile Engineering
- Production Technology
View More Questions
Questions Asked in TANCET exam
- The faces in a tetragon are
- TANCET - 2024
- Crystallography
- What letter replaces the question mark?
- What is in this sequence? Y, V, S, P, ___
- An intermediate shaft of a gearbox, supporting two spur gears A and B and mounted between two bearings C1 and C2, is shown in the below figure. The pitch circle diameters of gears A and B are 500 and 250 mm respectively. The shaft is made of alloy steel 20MnCr5. (\( S_{ut} = 620 \) and \( S_{yt} = 480 \) N/mm\(^2\)). The factors \( k_b \) and \( k_t \) of the ASME code are 2 and 1.5 respectively. The gears are keyed to the shaft. Determine the shaft diameter using the ASME code.
- TANCET - 2024
- Machine Design
- A train moving at 108 km/hr crosses a platform in 30 seconds. Then it crosses a man running at 12 km/hr in the same direction in 9 seconds. What is the length of train and platform in m?
- TANCET - 2024
- Time, Speed and Distance
View More Questions
TANCET Notification
GMC Azamgarh Admission 2025: Dates, Courses, Fees, Eligibility, SelectJuly 22, 2025GMC Azamgarh Admission 2025