Question:
Which component of gas turbine power plant is the main cause of its low efficiency?
Which component of gas turbine power plant is the main cause of its low efficiency?
Show Hint
The compressor in a gas turbine power plant consumes a large amount of energy to compress air, which significantly impacts the overall efficiency.
Updated On: May 4, 2025
- Compressor
- Starting motor
- Gas turbine
- Combustion chamber
Hide Solution
Verified By Collegedunia
The Correct Option is A
Solution and Explanation
In a gas turbine power plant, the compressor is the main cause of its low efficiency. The compressor requires significant energy to compress the air before it enters the combustion chamber, which reduces the overall efficiency of the plant. While other components like the turbine and combustion chamber also affect efficiency, the energy required by the compressor for air compression is typically a major limiting factor in the overall efficiency.
Thus, the correct answer is Compressor.
Was this answer helpful?
0
0
Top Questions on Power System Stability
- In a multi-machine interconnected power system, subsequent to a 3-phase fault, the transient stability is examined by:
- AP PGECET - 2024
- Electrical Engineering
- Power System Stability
- The Y-bus matrix of a 100-bus interconnected system is 90% sparse. Hence the number of transmission lines in the system must be:
- AP PGECET - 2024
- Electrical Engineering
- Power System Stability
- Which of the following types of faults does a bus differential relay NOT effectively detect?
- AP PGECET - 2024
- Electrical Engineering
- Power System Stability
- In a 220kV system, the inductance and capacitance up to the circuit breaker location are 25 mH and 0.025 micro Farads. The value of the resistor required to be connected across the breaker contacts which will give no transient oscillations is:
- AP PGECET - 2024
- Electrical Engineering
- Power System Stability
- Efficient Line-Commutated Converter (LCC) HVDC converters generally use:
- AP PGECET - 2024
- Electrical Engineering
- Power System Stability
View More Questions
Questions Asked in AP PGECET exam
The rank of matrix \(\begin{bmatrix} k & -1 & 0 \\[0.3em] 0 & k & -1 \\[0.3em] -1 & 0 & k \end{bmatrix}\) is 2, for \( k = \)
- AP PGECET - 2024
- Rank of a Matrix
If \(A = \begin{bmatrix} 4 & 2 \\[0.3em] -3 & 3 \end{bmatrix}\), then \(A^{-1} =\)
- AP PGECET - 2024
- Inverse of a Matrix
A two-port network is defined by the relation
\(\text{I}_1 = 5V_1 + 3V_2 \)
\(\text{I}_2 = 2V_1 - 7V_2 \)
The value of \( Z_{12} \) is:- AP PGECET - 2024
- Two Port Networks
An induction motor when started on load does not accelerate up to full speed but runs at \({\frac {1}{17}}\)th of the rated speed. The motor is said to be:
- AP PGECET - 2024
- Induction Motor
A 0 to 30 V voltmeter has an error of \(\pm 2\%\) of FSD. What is the range of readings if the voltage is 30V?
- AP PGECET - 2024
- Errors in Measurement
View More Questions