What will be the most suitable combination of three resistors A = 2 Ω, B = 4 Ω, C = 6 Ω so that \((22/3)\) Ω is equivalent resistance of combination?
- Parallel combination of A and C connected in series with B.
- Parallel combination of A and B connected in series with C
- Series combination of A and C connected in parallel with B.
- Series combination of B and C connected in parallel with A.
The Correct Option is B
Solution and Explanation
\(R_{eq} = \frac{2\times 4}{2+6}+6=\frac{22}{3}\)
⇒ A and B are in parallel and C is in series.
Top Questions on Resistance
- What is the resistance of a conductor if the potential difference across it is 12 V and the current flowing through it is 3 A?
- VITEEE - 2025
- Physics
- Resistance
- A coil of resistance 10 \( \Omega \) is connected to a battery of 12 V. If the current flowing through the coil is 2 A, what is the power dissipated in the coil?
- BITSAT - 2025
- Physics
- Resistance
- A resistor of resistance $ 10\, \Omega $ is connected across a $ 20\, V $ battery. Calculate the current flowing through the resistor.
- BITSAT - 2025
- Physics
- Resistance
A wire of resistance $ R $ is bent into a triangular pyramid as shown in the figure, with each segment having the same length. The resistance between points $ A $ and $ B $ is $ \frac{R}{n} $. The value of $ n $ is:
- JEE Main - 2025
- Physics
- Resistance
- Find the effective resistance of the network of resistors between points A and F as shown in the figure.
Questions Asked in JEE Main exam
- If the equation of the parabola with vertex $\left(\frac{3}{2},\, 3\right)$ and the directrix $x + 2y = 0$ is
$$ ax^2 + by^2 - cxy - 30x - 60y + 225 = 0, $$ then $\alpha + \beta + \gamma$ is equal to:- JEE Main - 2025
- Calculus
- In a first order decomposition reaction, the time taken for the decomposition of reactant to one fourth and one eighth of its initial concentration are $ t_1 $ and $ t_2 $ (s), respectively. The ratio $ t_1 / t_2 $ will be:
- JEE Main - 2025
- Chemical Kinetics
- HA $ (aq) \rightleftharpoons H^+ (aq) + A^- (aq) $ The freezing point depression of a 0.1 m aqueous solution of a monobasic weak acid HA is 0.20 °C. The dissociation constant for the acid is Given: $ K_f(H_2O) = 1.8 \, \text{K kg mol}^{-1} $, molality ≡ molarity
- JEE Main - 2025
- Colligative Properties
20 mL of sodium iodide solution gave 4.74 g silver iodide when treated with excess of silver nitrate solution. The molarity of the sodium iodide solution is _____ M. (Nearest Integer value) (Given : Na = 23, I = 127, Ag = 108, N = 14, O = 16 g mol$^{-1}$)
- JEE Main - 2025
- Stoichiometry and Stoichiometric Calculations
- Which of the following binary mixture does not show the behavior of minimum boiling azeotropes?
- JEE Main - 2025
- Solutions
Concepts Used:
Resistance
Resistance is the measure of opposition applied by any object to the flow of electric current. A resistor is an electronic constituent that is used in the circuit with the purpose of offering that specific amount of resistance.
R=V/I
In this case,
v = Voltage across its ends
I = Current flowing through it
All materials resist current flow to some degree. They fall into one of two broad categories:
- Conductors: Materials that offer very little resistance where electrons can move easily. Examples: silver, copper, gold and aluminum.
- Insulators: Materials that present high resistance and restrict the flow of electrons. Examples: Rubber, paper, glass, wood and plastic.
Resistance measurements are normally taken to indicate the condition of a component or a circuit.
- The higher the resistance, the lower the current flow. If abnormally high, one possible cause (among many) could be damaged conductors due to burning or corrosion. All conductors give off some degree of heat, so overheating is an issue often associated with resistance.
- The lower the resistance, the higher the current flow. Possible causes: insulators damaged by moisture or overheating.