Question:
What is the frequency of the waveform at Y?
What is the frequency of the waveform at Y?
Show Hint
To calculate the frequency of a waveform, consider any frequency division or multiplication factors that may be involved in the circuit configuration.
Updated On: July 22, 2025
- 2 kHz
- 3 kHz
- 4 kHz
- 6 kHz
Hide Solution
Verified By Collegedunia
The Correct Option is C
Solution and Explanation
- The frequency of the waveform at Y depends on the configuration of the circuit, particularly any oscillators or frequency division present in the circuit.
- If the frequency is divided by a certain factor, then the frequency at Y can be calculated based on that division. Given the options, 4 kHz seems to be the most appropriate frequency for the waveform at Y.
Conclusion: The frequency of the waveform at Y is 4 kHz.
Conclusion: The frequency of the waveform at Y is 4 kHz.
Was this answer helpful?
0
0
Top Questions on Digital Electronics and Logic Gates
- The difference between the minimum output voltage during logic high and the minimum input level during logic high of a logic family is referred to as ________.
- AP PGECET - 2025
- Electronics and Communication Engineering
- Digital Electronics and Logic Gates
- A bulb in a staircase has two switches, one at the ground floor and one at the first floor. The bulb can be turned ON or OFF by either switch, regardless of the other switch’s state. The logic of this switching resembles _______.
- AP PGECET - 2025
- Electronics and Communication Engineering
- Digital Electronics and Logic Gates
- The purpose of a matched filter in a digital communication receiver is to _______.
- AP PGECET - 2025
- Electronics and Communication Engineering
- Digital Electronics and Logic Gates
- M-ary encoding in Digital communication is done to achieve ________.
- AP PGECET - 2025
- Electronics and Communication Engineering
- Digital Electronics and Logic Gates
- The multiple access method used in Global Positioning Systems is ________.
- AP PGECET - 2025
- Electronics and Communication Engineering
- Digital Electronics and Logic Gates
View More Questions
Questions Asked in TANCET exam
- The faces in a tetragon are
- TANCET - 2024
- Crystallography
- What letter replaces the question mark?
- What is in this sequence? Y, V, S, P, ___
- An intermediate shaft of a gearbox, supporting two spur gears A and B and mounted between two bearings C1 and C2, is shown in the below figure. The pitch circle diameters of gears A and B are 500 and 250 mm respectively. The shaft is made of alloy steel 20MnCr5. (\( S_{ut} = 620 \) and \( S_{yt} = 480 \) N/mm\(^2\)). The factors \( k_b \) and \( k_t \) of the ASME code are 2 and 1.5 respectively. The gears are keyed to the shaft. Determine the shaft diameter using the ASME code.
- TANCET - 2024
- Machine Design
- A train moving at 108 km/hr crosses a platform in 30 seconds. Then it crosses a man running at 12 km/hr in the same direction in 9 seconds. What is the length of train and platform in m?
- TANCET - 2024
- Time, Speed and Distance
View More Questions
TANCET Notification
GMC Azamgarh Admission 2025: Dates, Courses, Fees, Eligibility, SelectJuly 22, 2025GMC Azamgarh Admission 2025