>
Exams
>
Automobile Engineering
>
Pollution and Control
>
the unit of emission for heavy vehicles is measure
Question:
The unit of emission for heavy vehicles is measured in:
Show Hint
Remember that emission standards vary by country and are crucial for reducing environmental impact and meeting regulatory requirements.
TANCET - 2024
TANCET
Updated On:
Feb 7, 2025
Mg/ms
g/km-s
g/km
g/kW.h
Hide Solution
Verified By Collegedunia
The Correct Option is
C
Solution and Explanation
Emissions for vehicles, especially heavy vehicles, are typically measured in grams per kilometer (g/km), which quantifies the amount of pollutants (like CO$_2$) emitted per kilometer driven.
Download Solution in PDF
Was this answer helpful?
0
0
Top Questions on Pollution and Control
Piston crevice volume is one of the reasons for ___________ emission:
TANCET - 2024
Automobile Engineering
Pollution and Control
View Solution
Which of the following materials is used in engine noise control?
TANCET - 2024
Automobile Engineering
Pollution and Control
View Solution
Blue smoke is caused by:
TANCET - 2024
Automobile Engineering
Pollution and Control
View Solution
AdBlue is:
TANCET - 2024
Automobile Engineering
Pollution and Control
View Solution
View All
Questions Asked in TANCET exam
The centrifugal force (N) acting on a material mass 2g present at the tip of a beater of radius 25 cm rotating at 600 rpm is
TANCET - 2024
Yarn Engineering
View Solution
Select the correct match
TANCET - 2024
Yarn Engineering
View Solution
Two yarns of count X each are doubled and plied. The ratio of resultant count of two ply yarn expressed in tex system and Ne system is_______. Neglect contraction due to twist.
TANCET - 2024
Yarn Engineering
View Solution
A reed has 15 dents/cm, and the warp is drawn in two ends per dent. If the finished fabric is 1.4 m wide compared with 1.47 m wide in the reed, what is the finished fabric sett?
TANCET - 2024
Fabric Engineering
View Solution
Among the following systems of drafting, the objective of which is to reduce the friction between adjacent warp ends?
TANCET - 2024
Fabric Engineering
View Solution
View More Questions