>
Exams
>
Automobile Engineering
>
Automotive Chassis
>
the rolling resistance does not depend upon
Question:
The rolling resistance does not depend upon
Show Hint
When optimizing vehicle efficiency, focus on tire pressure and tread patterns, which are significant factors affecting rolling resistance.
TANCET - 2024
TANCET
Updated On:
July 22, 2025
Velocity of the vehicle
Density of air
Construction of tyre
Mass of the vehicle
Hide Solution
Verified By Collegedunia
The Correct Option is
B
Solution and Explanation
Rolling resistance primarily depends on factors such as the tire's construction, the vehicle's mass, and its velocity, but not directly on the density of air. Air density impacts aerodynamic drag rather than rolling resistance.
Download Solution in PDF
Was this answer helpful?
0
0
Top Questions on Automotive Chassis
What is the angle between the steering axis and the vertical when viewed from the side of the vehicle?
TANCET - 2024
Automobile Engineering
Automotive Chassis
View Solution
Wheel alignment servicing equipment is used to measure:
TANCET - 2024
Automobile Engineering
Automotive Chassis
View Solution
When there is a reduction in amplitude over every cycle of vibration, then the body is said to have
TANCET - 2024
Automobile Engineering
Automotive Chassis
View Solution
Outer part of the tyre that extends from the bead to the tread is
TANCET - 2024
Automobile Engineering
Automotive Chassis
View Solution
View All
Questions Asked in TANCET exam
The faces in a tetragon are
TANCET - 2024
Crystallography
View Solution
What letter replaces the question mark?
TANCET - 2024
Series
View Solution
What is in this sequence? Y, V, S, P, ___
TANCET - 2024
Series
View Solution
An intermediate shaft of a gearbox, supporting two spur gears A and B and mounted between two bearings C1 and C2, is shown in the below figure. The pitch circle diameters of gears A and B are 500 and 250 mm respectively. The shaft is made of alloy steel 20MnCr5. (\( S_{ut} = 620 \) and \( S_{yt} = 480 \) N/mm\(^2\)). The factors \( k_b \) and \( k_t \) of the ASME code are 2 and 1.5 respectively. The gears are keyed to the shaft. Determine the shaft diameter using the ASME code.
TANCET - 2024
Machine Design
View Solution
A train moving at 108 km/hr crosses a platform in 30 seconds. Then it crosses a man running at 12 km/hr in the same direction in 9 seconds. What is the length of train and platform in m?
TANCET - 2024
Time, Speed and Distance
View Solution
View More Questions
TANCET Notification
GMC Azamgarh Admission 2025: Dates, Courses, Fees, Eligibility, Select
July 22, 2025
GMC Azamgarh Admission 2025
Read More