Question:
The properties of a material required to make permanent magnets are
The properties of a material required to make permanent magnets are
Show Hint
When selecting materials for permanent magnets, look for high retentivity and high coercivity to ensure long-lasting magnetism.
Updated On: May 9, 2025
- high retentivity and low coercivity
- high retentivity and high coercivity
- low retentivity and high coercivity
- low retentivity and low coercivity
Hide Solution
Verified By Collegedunia
The Correct Option is B
Solution and Explanation
To make permanent magnets, a material should have high retentivity, which ensures that the material can retain its magnetization, and high coercivity, which means the material resists being demagnetized. These properties are ideal for permanent magnets.
Was this answer helpful?
0
0
Top Questions on Magnetic Field
- Considering the case of magnetic field produced by air-filled current carrying solenoid, show that the magnetic energy density of a magnetic field \( B \) is \( \frac{B^2}{2\mu_0} \).
- CBSE CLASS XII - 2025
- Physics
- Magnetic Field
- A square loop of side 2 m lies in the Y-Z plane in a region having a magnetic field \(\mathbf{B} = (5 \hat{i} - 3 \hat{j} - 4 \hat{k}) \, \text{T}\). The magnitude of magnetic flux through the square loop is
- KCET - 2025
- Physics
- Magnetic Field
A thin transparent film with refractive index 1.4 is held on a circular ring of radius 1.8 cm. The fluid in the film evaporates such that transmission through the film at wavelength 560 nm goes to a minimum every 12 seconds. Assuming that the film is flat on its two sides, the rate of evaporation is:
- JEE Main - 2025
- Physics
- Magnetic Field
- An infinite wire has a circular bend of radius \( a \), and carrying a current \( I \) as shown in the figure. The magnitude of the magnetic field at the origin \( O \) of the arc is given by:
- JEE Main - 2025
- Physics
- Magnetic Field
- A uniform magnetic field of \( 0.4 \) T acts perpendicular to a circular copper disc \( 20 \) cm in radius. The disc is having a uniform angular velocity of \( 10\pi \) rad/s about an axis through its center and perpendicular to the disc. What is the potential difference developed between the axis of the disc and the rim? (\(\pi = 3.14\))
- JEE Main - 2025
- Physics
- Magnetic Field
View More Questions
Questions Asked in AP EAPCET exam
- Two bodies A and B of masses 1.5 kg and 3 kg are moving with velocities 20 m/s and 15 m/s respectively. If the same retarding force is applied on the two bodies, then the ratio of the distances travelled by the bodies A and B before they come to rest is
- AP EAPCET - 2025
- work, energy and power
- If a force F = (3i - 2j) N acting on a body displaces it from point (1 m, 2 m) to point (2 m, 0 m), then work done by the force is
- AP EAPCET - 2025
- work, energy and power
- If a position dependent force $(3x^2 - 2x + 7)N$ acting on a body of mass 2 kg displaces it from $x = 0\, m$ to $x = 5\, m$, then the work done by the force is
- AP EAPCET - 2025
- work, energy and power
- In a potentiometer experiment, a cell of emf 1.5 V gives a balance point at 75 cm. If the cell is replaced by another cell and the balance point is at 60 cm, the emf of the second cell is:
- AP EAPCET - 2025
- Current electricity
- When an ideal diatomic gas is heated at constant pressure, the fraction of the heat utilised to increase the internal energy of the gas is
- AP EAPCET - 2025
- Thermodynamics
View More Questions