The most appropriate process for manufacturing of plastic chair is
Show Hint
- injection molding
- extrusion
- calendering
- blow molding
The Correct Option is A
Solution and Explanation
- Other processes like extrusion, calendering, and blow molding are typically used for different plastic products such as pipes, films, and hollow parts, respectively.
Top Questions on Manufacturing Processes
- Group technology brings together and organizes:
- AP PGECET - 2025
- Mechanical Engineering
- Manufacturing Processes
- Which material is commonly used for pattern making?
- AP PGECET - 2025
- Mechanical Engineering
- Manufacturing Processes
- In wire drawing operation, the maximum reduction per pass for perfectly plastic material in ideal condition is:
- AP PGECET - 2025
- Mechanical Engineering
- Manufacturing Processes
- In metal cutting operations, discontinuous chips are produced while machining:
- AP PGECET - 2025
- Mechanical Engineering
- Manufacturing Processes
- CAD/CAM is hardware oriented, but gives it life.
- AP PGECET - 2025
- Mechanical Engineering
- Manufacturing Processes
Questions Asked in GATE PI exam
A regular dodecagon (12-sided regular polygon) is inscribed in a circle of radius \( r \) cm as shown in the figure. The side of the dodecagon is \( d \) cm. All the triangles (numbered 1 to 12 in the figure) are used to form squares of side \( r \) cm, and each numbered triangle is used only once to form a square. The number of squares that can be formed and the number of triangles required to form each square, respectively, are:
In the given figure, the numbers associated with the rectangle, triangle, and ellipse are 1, 2, and 3, respectively. Which one among the given options is the most appropriate combination of \( P \), \( Q \), and \( R \)?
- The left-hand side of a 20 cm thick wall is maintained at 25°C. The right-hand side of the wall is exposed to hot air at 50°C. There is no heat generation inside the wall and its thermal conductivity is 100 W/m·K. The convective heat transfer coefficient is 50 W/m²·K. Under steady state condition, the temperature (in °C) of the right-hand side surface of the wall is ........ (Rounded off to one decimal place).
- GATE PI - 2025
- Heat Transfer and Associated Losses
- Water flows through a smooth circular pipe of diameter 10 cm and length 10 m. The pressure drop across the length of the pipe is 0.2 Pa. Kinematic viscosity and density of water are \(1 \times 10^{-6} \, {m}^2/{s}\) and 1000 \({kg/m}^3\), respectively. Assuming laminar and fully developed flow throughout the pipe, the velocity of water (in mm/s) at the center of the pipe is ........ (Rounded off to one decimal place)
- GATE PI - 2025
- Fluid Mechanics
The table shows the data of running a machine for five years. The original machine cost is Rupees 70,000. In order to minimize the average total cost per year for running the machine, the machine should be replaced after ............. years. (Answer in integer)
- GATE PI - 2025
- Economic Activities