The methods chiefly used for the extraction of lead and tin from their ores are respectively
- self-reduction and carbon reduction
- self-reduction and electrolytic reduction
- carbon reduction and self-reduction
- cyanide process and carbon reduction
The Correct Option is A
Solution and Explanation
Top Questions on Concentration of ores
- Which of the following are carbonate ores?
I. Siderite
II. Kaolinite
III. Calamine
IV. Sphalerite- AP EAPCET - 2025
- Chemistry
- Concentration of ores
- Identify the sulphide ore among the following:
- TS POLYCET - 2025
- Chemistry
- Concentration of ores
- Which of the following methods is used for the concentration of ore?
- TS POLYCET - 2025
- Chemistry
- Concentration of ores
- Pyrolusite ore is:
- BCECE Nursing - 2024
- Chemistry
- Concentration of ores
- A → P is a zero-order reaction. At 298 K, the rate constant of the reaction is \( 1 \times 10^{-3} \) mol L\(^{-1}\) s\(^{-1}\). Initial concentration of 'A' is 0.1 mol L\(^{-1}\). What is the concentration of 'A' after 10 sec?
- AP EAMCET - 2024
- Chemistry
- Concentration of ores
Questions Asked in JEE Advanced exam
The left and right compartments of a thermally isolated container of length $L$ are separated by a thermally conducting, movable piston of area $A$. The left and right compartments are filled with $\frac{3}{2}$ and 1 moles of an ideal gas, respectively. In the left compartment the piston is attached by a spring with spring constant $k$ and natural length $\frac{2L}{5}$. In thermodynamic equilibrium, the piston is at a distance $\frac{L}{2}$ from the left and right edges of the container as shown in the figure. Under the above conditions, if the pressure in the right compartment is $P = \frac{kL}{A} \alpha$, then the value of $\alpha$ is ____
- JEE Advanced - 2025
- Thermodynamics
- The total number of real solutions of the equation $$ \theta = \tan^{-1}(2 \tan \theta) - \frac{1}{2} \sin^{-1} \left( \frac{6 \tan \theta}{9 + \tan^2 \theta} \right) $$ is
(Here, the inverse trigonometric functions $ \sin^{-1} x $ and $ \tan^{-1} x $ assume values in $[-\frac{\pi}{2}, \frac{\pi}{2}]$ and $(-\frac{\pi}{2}, \frac{\pi}{2})$, respectively.)- JEE Advanced - 2025
- Inverse Trigonometric Functions
- Let $$ \alpha = \frac{1}{\sin 60^\circ \sin 61^\circ} + \frac{1}{\sin 62^\circ \sin 63^\circ} + \cdots + \frac{1}{\sin 118^\circ \sin 119^\circ}. $$ Then the value of $$ \left( \frac{\csc 1^\circ}{\alpha} \right)^2 $$ is \rule{1cm}{0.15mm}.
- JEE Advanced - 2025
- Some Applications of Trigonometry
- One of the products formed from the reaction of permanganate ion with iodide ion in neutral aqueous medium is:
- JEE Advanced - 2025
- Redox reactions
Let $ S $ denote the locus of the point of intersection of the pair of lines $$ 4x - 3y = 12\alpha,\quad 4\alpha x + 3\alpha y = 12, $$ where $ \alpha $ varies over the set of non-zero real numbers. Let $ T $ be the tangent to $ S $ passing through the points $ (p, 0) $ and $ (0, q) $, $ q > 0 $, and parallel to the line $ 4x - \frac{3}{\sqrt{2}} y = 0 $.
Then the value of $ pq $ is- JEE Advanced - 2025
- Coordinate Geometry
Concepts Used:
Concentration of Ore
The concentration of ore, also known as ore enrichment, is the process of removing gangue particles from ore in order to enhance the percentage of metal in the ore. The difference in physical or chemical properties of the ore and the impurities determines the procedures used to remove impurities from the ores.
Methods of Concentration of Ore:
- Hand-picking - It was the traditional system of directly concentrating ore with the hands. With the use of a hammer, the gangue or adhering solid matrix is removed from the ore in this procedure. The separation and identification of gangue are based on colour or lump form differences.
- Hydraulic Washing - On passing the ore via an upward stream of water, the lighter gangue particles are separated from the heavier metal ore. This is a gravity separation method.This process is used to enrich ores that are heavier than the gangue particles that are present in them. A stream of water is run through crushed and finely powdered ore in this procedure. Water washes away the lighter gangue particles, leaving the larger ore particles behind.
- Froth Floatation Process - The purpose of this process is to extract gangue from sulfide ores. The ore is pulverized and mixed with water to form a suspension. Collectors and Froth Stabilizers are added to this. Collectors like pine oils, fatty acids, etc. boost the metal part of the ore’s non-wettability, allowing it to form a froth.