Question:
The impedance of Biopotential electrode is ————— at high frequency.
The impedance of Biopotential electrode is ————— at high frequency.
Updated On: Feb 27, 2025
- Low
- High
- Moderate
- Zero
Hide Solution
Verified By Collegedunia
The Correct Option is A
Solution and Explanation
At high frequencies, the impedance of biopotential electrodes tends to be low due to reduced capacitive reactance.
Was this answer helpful?
0
0
Top Questions on Biomedical Instrumentation
- A standard three-lead frontal plane ECG is taken from a person with a normal heart. The peak amplitude of R wave is
- TS PGECET - 2024
- Instrumentation Engineering
- Biomedical Instrumentation
- In an electromagnetic blood flow meter, the induced voltage is directly proportional to the
- TS PGECET - 2024
- Instrumentation Engineering
- Biomedical Instrumentation
- The treadmill test is used to diagnose
- TS PGECET - 2024
- Instrumentation Engineering
- Biomedical Instrumentation
- In the standard 12-lead ECG recording system, the minimum number of electrodes required to be attached to the human subject for recording any one of the unipolar chest lead signals is
- TS PGECET - 2024
- Instrumentation Engineering
- Biomedical Instrumentation
- IR spectroscopy
- TS PGECET - 2024
- Instrumentation Engineering
- Biomedical Instrumentation
View More Questions
Questions Asked in TANCET exam
- Bio-deterioration of hides and skin before tanning process, Hair slip occurs due to
- TANCET - 2024
- Pre-Tanning Operations
- What is in this sequence? Y, V, S, P, ___
- The faces in a tetragon are
- TANCET - 2024
- Crystallography
- What letter replaces the question mark?
- An intermediate shaft of a gearbox, supporting two spur gears A and B and mounted between two bearings C1 and C2, is shown in the below figure. The pitch circle diameters of gears A and B are 500 and 250 mm respectively. The shaft is made of alloy steel 20MnCr5. (\( S_{ut} = 620 \) and \( S_{yt} = 480 \) N/mm\(^2\)). The factors \( k_b \) and \( k_t \) of the ASME code are 2 and 1.5 respectively. The gears are keyed to the shaft. Determine the shaft diameter using the ASME code.
- TANCET - 2024
- Machine Design
View More Questions