>
Exams
>
Architecture
>
Alternative building materials
>
the defect of white decayed spots concealed by hea
Question:
The defect of white decayed spots concealed by healthy wood in timber is known as
Show Hint
Druxiness is caused by fungi and leads to the weakening of timber. It is essential to inspect timber for such defects before use.
TANCET - 2024
TANCET
Updated On:
Feb 27, 2025
Burls
Foxiness
Druxiness
Dead wood
Hide Solution
Verified By Collegedunia
The Correct Option is
C
Solution and Explanation
Druxiness is a defect in timber where white decayed spots, which are often concealed by healthy wood, occur due to fungal attack. This condition weakens the timber and makes it unsuitable for use in construction.
Download Solution in PDF
Was this answer helpful?
0
0
Top Questions on Alternative building materials
The time taken by hydraulic lime to slake is:
TANCET - 2024
Architecture
Alternative building materials
View Solution
Surkhi is added to lime mortar to impart the following property:
TANCET - 2024
Architecture
Alternative building materials
View Solution
The timber which is fully or partially covered with resin is known as
TANCET - 2024
Architecture
Alternative building materials
View Solution
Which one of the following statements regarding distemper is wrong?
TANCET - 2024
Architecture
Alternative building materials
View Solution
For M10 grade concrete, the proportion of cement, sand, and coarse aggregate is
TANCET - 2024
Architecture
Alternative building materials
View Solution
View More Questions
Questions Asked in TANCET exam
The faces in a tetragon are
TANCET - 2024
Crystallography
View Solution
What letter replaces the question mark?
TANCET - 2024
Series
View Solution
What is in this sequence? Y, V, S, P, ___
TANCET - 2024
Series
View Solution
An intermediate shaft of a gearbox, supporting two spur gears A and B and mounted between two bearings C1 and C2, is shown in the below figure. The pitch circle diameters of gears A and B are 500 and 250 mm respectively. The shaft is made of alloy steel 20MnCr5. (\( S_{ut} = 620 \) and \( S_{yt} = 480 \) N/mm\(^2\)). The factors \( k_b \) and \( k_t \) of the ASME code are 2 and 1.5 respectively. The gears are keyed to the shaft. Determine the shaft diameter using the ASME code.
TANCET - 2024
Machine Design
View Solution
A train moving at 108 km/hr crosses a platform in 30 seconds. Then it crosses a man running at 12 km/hr in the same direction in 9 seconds. What is the length of train and platform in m?
TANCET - 2024
Time, Speed and Distance
View Solution
View More Questions