The ammeter A reads 2 A and the voltmeter V reads 20 V. The value of resistance R is:
- less than 10 ohm
- more than 10 ohm
- we cannot definitely say
The Correct Option is C
Solution and Explanation
Top Questions on Resistance
- Two wires A and B are made up of the same material and have the same mass. Wire A has radius \(2.0 \, \text{mm}\) and wire B has radius \(4.0 \, \text{mm}\). The resistance of wire B is \(2 \, \Omega\). The resistance of wire A is _____ \( \Omega \).
- JEE Main - 2024
- Physics
- Resistance
- To determine the resistance \( R \) of a wire, a circuit is designed below. The V-I characteristic curve for this circuit is plotted for the voltmeter and the ammeter readings as shown in the figure. The value of \( R \) is \( \dots \dots \dots \Omega \).
- JEE Main - 2024
- Physics
- Resistance
A 16Ω wire is bent to form a square loop. A 9 V battery with internal resistance 1Ω is connected across one of its sides. If a 4μF capacitor is connected across one of its diagonals, the energy stored by the capacitor will be \(\frac{x}{2}\) μJ, where \(x =\) _____.
- JEE Main - 2024
- Physics
- Resistance
- A wire of resistance \( R \) and length \( L \) is cut into 5 equal parts. If these parts are joined in parallel, then the resultant resistance will be:
- JEE Main - 2024
- Physics
- Resistance
A galvanometer having coil resistance 10 Ω shows a full scale deflection for a current of 3 mA. For it to measure a current of 8 A, the value of the shunt should be:
- JEE Main - 2024
- Physics
- Resistance
Questions Asked in JIPMER exam
- Binomial nomenclature was first introduced by
- JIPMER - 2015
- KCET - 2022
- Diversity In The Living World
- A convex lens $'A'$ of focal length $20\, cm$ and a concave lens $'B'$ of focal length $5\, cm$ are kept along the same axis with a distance $'d'$ between them. If a parallel beam of light falling on $'A'$ leaves $'B'$ as a parallel beam, then the distance $'d'$ in cm will be :
- JIPMER - 2021
- Spherical Mirrors
- A bacterial flagellum is composed of
- JIPMER - 2021
- Prokaryotic Cells
- $2,4-DNP $ test can be used to identify :
- JIPMER - 2021
- Chemical Reactions
- How many moles of acidified $K_2Cr_2O_7$ is required to liberate $6$ moles of $I_2$ from an aqueous solution of $I^-$ ?
- JIPMER - 2020
- Mole concept and Molar Masses
Concepts Used:
Resistance
Resistance is the measure of opposition applied by any object to the flow of electric current. A resistor is an electronic constituent that is used in the circuit with the purpose of offering that specific amount of resistance.
R=V/I
In this case,
v = Voltage across its ends
I = Current flowing through it
All materials resist current flow to some degree. They fall into one of two broad categories:
- Conductors: Materials that offer very little resistance where electrons can move easily. Examples: silver, copper, gold and aluminum.
- Insulators: Materials that present high resistance and restrict the flow of electrons. Examples: Rubber, paper, glass, wood and plastic.
Resistance measurements are normally taken to indicate the condition of a component or a circuit.
- The higher the resistance, the lower the current flow. If abnormally high, one possible cause (among many) could be damaged conductors due to burning or corrosion. All conductors give off some degree of heat, so overheating is an issue often associated with resistance.
- The lower the resistance, the higher the current flow. Possible causes: insulators damaged by moisture or overheating.