>
Exams
>
Biomedical Engineering
>
Biomedical Instrumentation
>
respiration rate is measured using
Question:
Respiration rate is measured using —————.
TANCET - 2024
TANCET
Updated On:
Feb 27, 2025
RTD
Strain gauge
Ultrasonics
Thermocouple
Hide Solution
Verified By Collegedunia
The Correct Option is
C
Solution and Explanation
Ultrasonic sensors are commonly used for non-invasive measurement of respiration rates by detecting chest wall movements.
Download Solution in PDF
Was this answer helpful?
0
0
Top Questions on Biomedical Instrumentation
A standard three-lead frontal plane ECG is taken from a person with a normal heart. The peak amplitude of R wave is
TS PGECET - 2024
Instrumentation Engineering
Biomedical Instrumentation
View Solution
In an electromagnetic blood flow meter, the induced voltage is directly proportional to the
TS PGECET - 2024
Instrumentation Engineering
Biomedical Instrumentation
View Solution
The treadmill test is used to diagnose
TS PGECET - 2024
Instrumentation Engineering
Biomedical Instrumentation
View Solution
In the standard 12-lead ECG recording system, the minimum number of electrodes required to be attached to the human subject for recording any one of the unipolar chest lead signals is
TS PGECET - 2024
Instrumentation Engineering
Biomedical Instrumentation
View Solution
IR spectroscopy
TS PGECET - 2024
Instrumentation Engineering
Biomedical Instrumentation
View Solution
View More Questions
Questions Asked in TANCET exam
What is in this sequence? Y, V, S, P, ___
TANCET - 2024
Series
View Solution
What letter replaces the question mark?
TANCET - 2024
Series
View Solution
An intermediate shaft of a gearbox, supporting two spur gears A and B and mounted between two bearings C1 and C2, is shown in the below figure. The pitch circle diameters of gears A and B are 500 and 250 mm respectively. The shaft is made of alloy steel 20MnCr5. (\( S_{ut} = 620 \) and \( S_{yt} = 480 \) N/mm\(^2\)). The factors \( k_b \) and \( k_t \) of the ASME code are 2 and 1.5 respectively. The gears are keyed to the shaft. Determine the shaft diameter using the ASME code.
TANCET - 2024
Machine Design
View Solution
A train moving at 108 km/hr crosses a platform in 30 seconds. Then it crosses a man running at 12 km/hr in the same direction in 9 seconds. What is the length of train and platform in m?
TANCET - 2024
Time, Speed and Distance
View Solution
The speed of a motor boat in still water is 7km/hr. If the speed of the motor boat against the stream is 5 km/hr, what is the speed of the stream?
TANCET - 2024
Time, Speed and Distance
View Solution
View More Questions