Question:
Negative skin friction in a soil is considered when the pile is constructed through
Negative skin friction in a soil is considered when the pile is constructed through
Show Hint
For pile foundation design, be mindful of the effects of negative skin friction, particularly when piles are installed in fill material.
Updated On: May 3, 2025
- Dense coarse sand
- Dense fine sand
- Fill material
- Over consolidated stiff clay
Hide Solution
Verified By Collegedunia
The Correct Option is C
Solution and Explanation
Negative skin friction occurs when the surrounding soil settles after the pile is placed, causing resistance against the pile. This is more likely to occur when the pile is installed in fill material or loose soils that settle over time. Hence, the correct answer is Fill material.
Was this answer helpful?
0
0
Top Questions on Soil Mechanics
- For a right-hand offset disc harrow, the longitudinal distance from the hitch point to the centers of the front and rear gangs are 2.5 m and 4.5 m, respectively. The resultant horizontal soil forces in longitudinal direction on the front and rear gangs are 3.0 kN and 3.5 kN, respectively; while the resultant horizontal soil forces in lateral directions are 2.5 kN and 4.0 kN, respectively. Considering the resultant soil forces acting at the centers of front and rear gangs, the amount of offset of the center of cut with respect to the hitch point is _________ m. (Rounded off to 2 decimal places)
- A horizontal axis wind turbine with 24 m diameter blades, running with an average wind velocity of 6.0 m.s\(^{-1}\), is used for pumping irrigation water. The average air density is 1.23 kg.m\(^{-3}\). Considering coefficient of power as 0.3, transmission efficiency as 90%, pump efficiency as 60%, acceleration due to gravity as 9.81 m.s\(^{-2}\) and density of water as 1000 kg.m\(^{-3}\), the discharge of the pump for a total head of 20 m is _________ L.s\(^{-1}\). (Rounded off to 2 decimal places)
- An 8 ha watershed receives rainfall intensities of 2.5, 3.6, 5.4, 3.3, 2.6 and 1.2 cm.h\(^{-1}\) at the successive intervals of 30 minutes. The corresponding surface runoff volume is estimated to be 4800 m\(^3\). Neglecting initial abstraction losses, the W-index for this watershed is _________ cm.h\(^{-1}\) (Rounded off to 2 decimal places).
- To protect a wheat field from wind erosion, windbreaks of 2.7 m height are provided. The actual wind velocity at 15 m height perpendicular to the wind barrier is 9 m.s\(^{-1}\) and the minimum wind velocity at 15 m height required to move the most erodible soil fraction is 9.6 m.s\(^{-1}\). The distance of full protection from this windbreak is _________ m. (Rounded off to 2 decimal places)
- Water flows through a 90° V-notch weir having a discharge coefficient of 0.6. If the depth of water above the notch is 49 cm and the acceleration due to gravity is 9.81 m.s\(^{-2}\), the discharge over the notch is _________ m\(^3\).s\(^{-1}\) (Rounded off to 2 decimal places).
View More Questions
Questions Asked in AP PGECET exam
The rank of matrix \(\begin{bmatrix} k & -1 & 0 \\[0.3em] 0 & k & -1 \\[0.3em] -1 & 0 & k \end{bmatrix}\) is 2, for \( k = \)
- AP PGECET - 2024
- Rank of a Matrix
If \(A = \begin{bmatrix} 4 & 2 \\[0.3em] -3 & 3 \end{bmatrix}\), then \(A^{-1} =\)
- AP PGECET - 2024
- Inverse of a Matrix
A two-port network is defined by the relation
\(\text{I}_1 = 5V_1 + 3V_2 \)
\(\text{I}_2 = 2V_1 - 7V_2 \)
The value of \( Z_{12} \) is:- AP PGECET - 2024
- Two Port Networks
An induction motor when started on load does not accelerate up to full speed but runs at \({\frac {1}{17}}\)th of the rated speed. The motor is said to be:
- AP PGECET - 2024
- Induction Motor
A 0 to 30 V voltmeter has an error of \(\pm 2\%\) of FSD. What is the range of readings if the voltage is 30V?
- AP PGECET - 2024
- Errors in Measurement
View More Questions