In an assembly comprising shaft and hole, the nominal sizes with tolerances are specified as
Hole: \(25.000^{+0.002}_{-0.001}\) mm,
Shaft: \(25.000^{+0.001}_{-0.003}\) mm.
The type of fit is
Hole: \(25.000^{+0.002}_{-0.001}\) mm,
Shaft: \(25.000^{+0.001}_{-0.003}\) mm.
The type of fit is
Show Hint
- Clearance fit
- Interference fit
- Transition fit
- Running fit
The Correct Option is C
Solution and Explanation
Final Answer: Transition fit
Top Questions on Limits, Fits and Tolerances
- In a shaft-hole assembly, the hole is specified as \( 30.040^{0.000} \) mm. The mating shaft has a clearance fit with minimum clearance of 0.01 mm. The tolerance on the shaft is 0.03 mm. The maximum clearance in mm between the hole and the shaft is
- GATE PI - 2021
- Production Engineering (Manufacturing)
- Limits, Fits and Tolerances
- ‘GO’ and ‘NO GO’ snap gauges are to be designed for a shaft \( 36.000^{+0.070} \, +0.010 \) mm. Gauge tolerance can be taken as 5% of the hole tolerance. Following the ISO system of gauge design, the respective sizes of ‘GO’ and ‘NO GO’ gauges are
- GATE PI - 2021
- Production Engineering (Manufacturing)
- Limits, Fits and Tolerances
Questions Asked in GATE PI exam
The zero line of the Vernier scale lies between divisions 20 and 21 of the main scale. The 4th Vernier scale division exactly coincides with a main scale division. The 5 divisions of the Vernier scale are equal to 4 divisions of the main scale. If one main scale division is 1 mm, the measured value (in mm) is ........... (Rounded off to one decimal place)}
- GATE PI - 2025
- Industrial and Production
- Water flows through a smooth circular pipe of diameter 10 cm and length 10 m. The pressure drop across the length of the pipe is 0.2 Pa. Kinematic viscosity and density of water are \(1 \times 10^{-6} \, {m}^2/{s}\) and 1000 \({kg/m}^3\), respectively. Assuming laminar and fully developed flow throughout the pipe, the velocity of water (in mm/s) at the center of the pipe is ........ (Rounded off to one decimal place)
- GATE PI - 2025
- Fluid Mechanics
The table shows the data of running a machine for five years. The original machine cost is Rupees 70,000. In order to minimize the average total cost per year for running the machine, the machine should be replaced after ............. years. (Answer in integer)
- GATE PI - 2025
- Economic Activities
A company purchases items in bulk for getting quantity discounts in the item’s price. The price break-up is given in the table. The annual demand for the item is 5000 units. The ordering cost is Rupees 400 per order. The annual inventory carrying cost is 30 percent of the purchase price per unit. The optimal order size (in units) is .......... (Answer in integer)
- GATE PI - 2025
- Industrial and Production
Three plants P1, P2, and P3 produce 6, 1, and 9 thousand liters of fruit juice, respectively. The produced fruit juice is transported to three distribution centers D1, D2, and D3 with a requirement of 7, 5, and 4 thousand liters of juice, respectively. The transportation cost (in hundreds of Rupees) from each plant to each distribution center is given in the table. The total transportation cost (in hundreds of Rupees) in the initial basic feasible solution using Vogel’s approximation method is ............. (Answer in integer)
- GATE PI - 2025
- Industrial and Production